Cluctch sleeve in 1999 miatia how much to fix clutch goes to floor

The Clutch Master Cylinder or the Clutch Slave Cylinder has a leak. From under the dashboard, located the Clutch Master Cyliner Boot and pry one side open. If hydraulic fluid drips out, the piston seal(s) in the cylinder are worn. You'll need to replace the cylinder.

But check in see if it's just the ball joints first that's a easy fix compared to replacing the whole clutch I have a 1999 Ford escort manual and just had this problem I know all I need to know about this car make and model trust me it's your clutch nothing else You are soon to run into belt problems too keep an eye on that

You will have to be more specific in order to get help on this site .... does the clutch go to the floor randomly without pushing it with your foot? Does it just go to the floor when you press it with your foot? If the last is yes then does the transmission disengage when the clutch goes to the floor as it should or does something else happen? Normally you would want your clutch to go to the floor ... see where I'm going with this?

Hello there
By clutch you mean pedal right?You most likely need to bleed the sleeve cylinder(it is on side of the transmission) .Make sure you have enough brake fluid in reservoir where the break fluid goes it is shared with the clutch.You probably have air in system.
let me know..

proporsche

i had the same problem on a 1999 miatia took to shop they said i needed a new clutch sleeve it cost me 300

Clutch safety switch. Prevents the car from starting unless the clutch pedat is depressed all the way to the floor.

hi, if the pedals on the floor the clutch cable has snapped. will need replacement. please locate the cable and see if it has a part number on the outer sleeve. this may be an easy fix it depends on routing through the firewall. if this is a hydrolic clutch the master cylinder is been leaking or either completely empty of (brake fluid used for the clutch) or the clutch pipe has burst (wo'nt HOLD ANY PRESSURE). the thrust bearing has gone through the diaphram (this is a large fingered spring on the clutch to release drive to the gearbox). the gearbox will need to come out if this is the case i hope i have answered and. gerry

Broken clutch cable.
If clutch is hydraulic , leak in the system or bad clutch slave or master cylinder.

cluctch is not properly adjusted or they didn't replace the pressure plate?

Your car uses what is called a hydraulic clutch, the master or the slave hydraulic cylinder is leaking fluid and you have no pressure in the system, this causes the clutch to go to the floor.