I need to know where to find the child anchor for a 1996 dodge caravan

Bolting in child seats is rather old fashioned since a range of child seats arrived on the market that are designed to be retained by the vehicle's own seat belts.
These seats are easily swapped between vehicles, are safe and secure and widely available.

I haven't needed to bolt in a child seat for nearly 20 years but I used to fit many for my customers. It was invariably impossible to piggyback the upper strap mounts onto the vehicle seatbelt anchor points and new mounts had to be drilled after removing seats and trim. Sometimes it was possible to piggyback the lower mounts. So far I haven't encountered any car with pre-installed child seat mounts.

disengage the saftey Anon, I believe it is done on the overhead console or if you mean the child prevention lock, it is a small switch by the doors latching assembly. Links below give instruction.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Thread 2011 Grand Caravan Sliding Door Child Safety Lock Engaging on its...

Dodge 2006 Grand Caravan User Manual

How To Install Replace Power Sliding Door Lock Actuator Chrysler Town and...

I don't know, what do you want to do with it? Fix it, rebuild it, scrap it, boat anchor? It is worth money at the scrap yard, If you need it fixed, manual trannys are easier to fix than autos. The transmission shop might want it for parts. Hope this helps.

Not sure what size of 6 cylinder you have so please pick the correct one for your motor size:

1996 Dodge Caravan
3.8 liter V-6 VIN "L"



1996 Dodge Caravan
3.3 liter V-6 VIN "R"




1996 Dodge Caravan
3.0 liter V-6 VIN "3"

You didn't post your engine size so please pick the one that is applicable to you:
1996 Dodge Caravan
2.4 liter DOHC L4 VIN "B"


1996 Dodge Caravan
3.0 liter V-6 VIN "3"




1996 Dodge Caravan
3.3 liter V-6 VIN "R"




1996 Dodge Caravan
3.8 liter V-6 VIN "L"

no ,too early

would not advise fitting a front seat baby seat .

The rear seat child restraint anchors were not required (by law) until early 2000's. Most likely your car does not have them.

This site shows all the recalls for the car. It says there was a recall b/c of the instructions manual and how to use the anchors. Hopefully this will help.

http://www.internetautoguide.com/auto-recalls/09-int/2000/dodge/intrepid/index.html

The most common size is a T-50 Torx socket.