Question about 2008 Mitsubishi Lancer GTS CVT Sedan
Locate the two belts on the left
side (passenger side) of your Mitsubishi Lancer. The outer belt is a
serpentine belt, operating four pulleys and the inner belt is your
Posted on Oct 25, 2011
IF YOU HAVE AUTOMATIC BELT TENSIONER ITS BROKEN IF BELT KEEP COMING OFF. TENSIONER NOT KEEPING TENSION ON DRIVE BELT TO KEEP IT IN PLACE.IF YOU DONT HAVE AUTOMATIC BELT TENSIONER YOU HAVE TO LOOSEN ALTERNATOR SUPPORT NUT, LOOSEN THE ADJUSTER LOCK BOLT, ROTATE THE ADJUSTER BOLT CLOCKWISE UNTIL PROPER TENSION REACHED, TIGHTEN THE ADJUSTER LOCK BOLT AND THE ALTERNATOR SUPPORT NUT.
Posted on Oct 25, 2011
Tips for a great answer:
Dec 04, 2013 | 1999 Chevrolet Malibu
Dec 29, 2012 | 2001 Dodge Caravan
Dec 11, 2012 | 1997 Ford Windstar
Nov 18, 2017 | Ford Escort Cars & Trucks
Oct 25, 2011 | 2008 Mitsubishi Lancer GTS CVT Sedan
Locate the two belts on the left side (passenger side) of your Mitsubishi Lancer. The outer belt is a serpentine belt, operating four pulleys and the inner belt is your alternator belt.
Follow the serpentine (outer) belt to the three pulleys lined up vertically near the front of the engine compartment. Locate the middle pulley, which is the tension pulley for the belt.
Loosen the bolt on the middle pulley with a socket wrench by turning counter-clockwise. Do not remove the bolt, just turn it a couple of times. Loosen the tensioner bolt on the side of the of the pulley, facing the front of the vehicle.
Remove the serpentine belt and then loosen the bolt on the alternator. With the alternator loose, move it forward so that the alternator belt loosens up and then remove belt from the pulleys.
Install the new alternator belt by placing it over both inside pulleys. Tighten the tension on the alternator belt by moving the alternator back and keeping tension on it by holding it back with a long screwdriver. While the alternator belt is tight, use a socket wrench to tighten up the bolt on the alternator.
Place the serpentine belt back on the pulleys and then use a socket wrench on the bolt on the front of the tension pulley. Once the serpentine belt is tight, tighten up the bolt in the middle of the tension pulley.
Start the Mitsubishi Lancer's engine to test the alternator belt and make sure it is working properly. Once you have verified it is working, turn the engine off.
Oct 08, 2010 | 2002 Mitsubishi Lancer
Feb 20, 2010 | 2008 Mitsubishi Lancer GTS CVT Sedan
Nov 21, 2009 | 2008 Mitsubishi Lancer GTS CVT Sedan
Oct 10, 2016 | 2008 Mitsubishi Lancer GTS CVT Sedan
1,200 people viewed this question
Usually answered in minutes!