Its pretty simple
Remove the drive shaft
remove the tires
remove the calipers and rotors if rear disk and then remove the ebrake shoes/cables.
If rear drums remove the drums. remove the shoes and the e brake cable. remove the backing plate bolts. remove backing plate from axle and support with a piece of wire from the frame being careful not to distort the brake line.
remove the bolt that holds the breather an brake junction to the axle.
remove the break line from the tabs (may not have them).
remove the shocks from the axle.
remove the u-bolts from the axle.
pull the axle out.
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
also if rear drum you will need to pull the axles to remove the backing plates. or you can remove the brake line from the wheel cylinders and leave the backing plates on. To remove the axles you will need to pull the diff cover. Rotate the diff until the diff pin bolt is accessible. Remove the bolt, pull the pin, push the axles inward, drop the c-clips, then pull the axles out.
×
SOURCE: Procedure for changing the front and rear axel oil
this is rather simple pull the drain plugs and refill till it starts to run out of top plug besure to use proper gear oli for your vehicel
423 views
Usually answered in minutes!
×