Question about 2003 Mitsubishi Lancer

1 Answer

2003 LANCER 2.OLT=REPLACED BATTERY,REPLACED 100AMP [email protected]=CAR TURNS OVER BUT WON'T START! A JUMP START WAS ATTEMPTED BUT BELIEVE THEY CROSSED THE CABLES! HELP !

Posted by brivers916 on

Ad

1 Answer

WilsonDavid

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

[email protected] all the fuses and relays in the 2 boxes under the hood and another one of fuses and relays panel inside the car, front of the driver seat, behind the pull out box next to the hood release handle..Under the hood check inside the one with 8" black square box;Check # 1 slot fuse, it is 60 amps for (+B ), check # 8 slot fuse for Engine control 20 amps, check # 15 slot Fuel pump 15 amps..And check another skinny black box lie next to that box, it has relay F, that is Engine control, check that also...And inside the car fuses panel; Check # 1 slot fuse 10 amps that for Ignition coil, # 8 slot Engine control 7.5 amps, # 12 slot Engine control 7.5 amps..After that recheck the battery post, that maybe needed re-tight..Don't force to tight too much, that will crack and broke the post and the plastic battery body...And check all the ignition wires and spark plugs that are tight or needed to replace..And check all the vacuum lines that are loose and leaks suctions or sometimes they are crack open by long ages..By the way check and recheck all those other fuses and relay for make sure they are good...Believe me that not hard to figure out those problems..You did everything rights so far..That one 100 amps fuse at the + battery post cable was connect to alternator for recharging your battery and give power to other items when car was running..Below that post, the middle cable was connect to the starter motor and the bottom cable was connect to that 8" black fuses and relays box under the hood...

Posted on Sep 22, 2011

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I jumped car off it crunk on its own fora day,then batt went dead again,this time it won't jump off. It wants to crank but won't turn over.


not sure what you said but.
seems the battery is discharging,? 12.6v is fully charged,
own a voltmeter?
try a good loaned battery , does it start the car,?
i think you meant?
i can jumper cable start my car at any time. (off another running car)
but after running my car, the battery discharges and it will not crank at all. right?
this means ,the charging system on your car is bad.
if the starter cranks great, then the engine is flooded or is in great need of a tune up (sparkplugs etc)
if flooded try the super secret in the op guide, crank with throttle wide open , this magic trick cuts all fuel injection allowing the flooding
to purge away, and eventual starting.
my guess 2 is the car wont start, so you crank the battery flat
you jumper start it and it runs. (luck)
then day 2, same deal cranks ok but wont start.. ever tune up the engine?

Feb 08, 2013 | 2007 Suzuki Forenza Sedan

1 Answer

Won't crank has new battery


if the lights come on you'r getting juice from the batt,if they go out when you crank the motor over batt is bad or you have bad batt connections

Aug 27, 2012 | 2000 GMC Jimmy

1 Answer

My 1997 Subaru Impreza won't turn over.


here is a trick ...jump it off and unhook + batt cable if car shuts off alternator if stays on replace batt

Aug 16, 2012 | 2002 Subaru Legacy

1 Answer

2003 tiburon turns over but won't start


those are screwed in there usually. as far as it blowing...thats from you hooking up the charger or the jumper cables backwards. and yes,that will make it not start.

Mar 24, 2012 | 2003 Hyundai Tiburon

3 Answers

My 2003 lancer over heated and won't start now.


too late, but the answer is: when the water system loses enough water, there is a sensor in the water inlet that tells the computer that there is no water, then the computer will not allow the engine to start, I check it on a radiator change I had to make a lancer 2006, we wanted to move the car a few meters but did not start because the hoses were not installed and the block had no water, so we had to start pouring water with a garden hose to the water inlet of the block and in that way started the engine.

Sep 16, 2011 | 2003 Mitsubishi Lancer

1 Answer

"2003 Chevy Impala won't start". Car would not


The alternator is not charging,or the battery wont take a charge.If all accessories work fine when its running after you've boosted it,its likely the battery.
John

Sep 05, 2011 | 2003 Chevrolet Impala

1 Answer

I helped a friend recently who had an issue with a dead battery. she had a dead battery and the security at the place tried to jump her and I believe they crossed the cables. When I got there the battery...


if the jumper leads were crossed it means that there would be 24 volts going into the system instead of 12 volts, you are very lucky that the car still starts as this action usually causes major damage to the electronic parts of the vehicle so I don' think that they were crossed but it has caused some sort of problem but I'm not sure where,it maybe best to take the vehicle to an auto electrician & have the problem fixed.....hope this helps.....cheers.

Jun 30, 2011 | 2002 Toyota RAV4

Not finding what you are looking for?
2003 Mitsubishi Lancer Logo

459 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...