My 2006 F-150 drivers side control panel is dead & none of the electric windows, locks, mirrors or door sensor will work. I checked all the fuses & they are fine. The passenger door sensor & electric lock works but not the window. It may be a bad wire through the drivers side door because the controls worked briefly when the door was open in a certain position. I need a quick fix or a permanent solution - my windows are partially down and I can't take it to the shop now.

turns fail. 2003.?
so did not check all fuses first then scan the OBD2 port next
ooops, why skip those?

lots they are what do they all do good and bad.?
well fuses are blown why skip step on, electrics, all fuses checked,
"changed flasher"<<, why say that. then not say turns and hazards fail too or not????? i have a real oem shop manual for this car. USA spec car is it>?
w cant guess countries of VIN to know it
chapter 8w wiring, is clear and easy to read.

8w-60 and 61 locks and windows. schematics and all
not the fuse for windows it runs both sides. F12 , 50amps.
do door locks fail using key fob??????????? any?
F12 also runs door locks but is not bad. only for 1 door.

right door inside lock controls dead?too?
you have a fob
and lots of door controls switches, it is clear which fail and do not
front and rear, both.

the door control modules on this car use COMM buse
called PCI serial bus this car
so commands from any in car button or fob must work and send commands to t the door commanded, via PCI bus.
same goes for windows ,door control modules

bad comms
or the origination command device fails, the FOB or the door buttons afail
all doors have controls do only right side fail and fob too?

try testing at all doors first
and the fob too.
off hand seems PCI bus wires damaged on the right side.

1- Door locks 2- Windows 3- Seat control 4- Drivers side mirror control 5- Drivers side mirror 6- Locks don't work To access these controls you need to use the "code" to unlock them. I cannot remember the code now but try texting me and I'll send the code to you.

Check the wire bundle coming in to the door at hinge side. It is a short or broken wire

Check the switch module for disconnected.

Sounds like the master switch is not plugged in properly, this is the switch in the driver's door.

It sounds like it could be one fuse or several. It also could be your door control module.

The first thing to do would be to hook up a factory or professional type scan tool an check for DTC'S - diagnostic trouble code's . This vehicle has very complex electronic's. Serial data communication network,class2 data bus . There are electronic modules inside the door's that control the lock's ,power window's , power mirror's . Your best bet ,take it to a qualified repair shop . Not a fuse problem , driver an passenger door module each have thier own power supply. Two circuit breakers ,PWR/WDO circuit breaker 30 amp. You could check DRVMDL 10amp fuse ,located in the rear fuse box , PASSMDL 10amp fuse rear fuse box , RRDR/MDL 10 amp fuse rear fuse box . Rear fuse box is under the back seat . None of the window's , lock's etc.. work from any door switch ?

CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

slide the rubber boot up and check the wires in the hinge of the doors. I will bet anything that the wires are broken. that was what was wrong with mine. just splice them back together and everything should work fine.

i have had this issue before all i had to do is do a new ground, jumped the safety window lock, as well as expanding the metal clips in the wire con.