Cadillac catera 01' odometer and trip meter stopped working at exactly 73,200 miles - everything else in the gauge cluster still works.

Check your wiring connectors for loose wires. use a safety pin and push all the wires in from the back.

Odometer and Trip Meter Stopped Working - AcuraZine Community

acurazine.com/forums/.../odometer-trip-meter-stopped-working-757772/

Dec 29, 2009 - The tech said he has seen the odometer & trip meter not workingbeing ... I have a 1997 TL and the same exact thing happened to me today. speedometer,trip and odometer not working
Aug 5, 2012
Cannot reset Trip A or Trip B on New 2012 MDX
Aug 1, 2012
Trip meter resets itself
Jul 25, 2012
Trip Computer Reset feature (with refuel) question..
Dec 19, 2009
More results from acurazine.com

Acura TL odometer trip meter not working Questions ... - Fixya

www.fixya.com/tags/odometer_trip_meter_not_working/cars/acura/tl

There where many problems with the gauges in this year, pull the cluster out and send it in to be rebuilt.

If I had a 1998 car with 218K miles on it and an unimportant thing like the trip meter didn't work I would put a piece of black tape over it and use a GPS as my trip meter.

My guess would be a bad connection at the harness for the cluster, or a problem with the printed circuit board inside the cluster.

Duplicate post

Try this, it works on other Chrysler products.

Insert key and turn to run position. put odometer on the trip position. turn key off.

While holding trip meter reset button in, turn key to run position ( dash lights will be on ) release trip meter reset button and watch the gauge cluster go through a test cycle.

After this cycle the gauges should return back to normal.

Hope this works for you.

IF YOUR SPEEDO IS WORKING THEN YOUR VSS IS OKAY, BAD VSS WILL STOP SPEEDO AND USALLY CAUSE HARD SHIFTING. NORMALLY ODO IS CONTROLLED BY SERVO MOTOR WHICH MAY HAVE WENT OUT. CHECK EBAY FOR REPAIR SERVICES OR SIMPLY GET A SALVAGE CLUSTER AND HAVE MILEAGE RESET

check your speedo cable it runs from your transmission to the back of your gauge cluster. its probleby broken or disconnected

Section 13-01: Instrument Cluster—Conventional 1995 Thunderbird, Cougar Workshop Manual REMOVAL AND INSTALLATION Instrument Cluster Removal and Installation

1. Disconnect battery ground cable (14301) .

1. Remove screws holding instrument panel reinforcement (017A28) .

1. Remove screws holding instrument panel lower shield (045G02) .

1. Remove fasteners holding steering wheel column as outlined in Section 11-04 . Gently lower steering column.

1. Remove fasteners holding the instrument panel finish panel (044D70) and gently pry off.
   
   
   
   

1. Remove four instrument cluster retaining screws. (Do not remove screws from the instrument cluster main lens (10887) and instrument cluster mask (10890) ).

1. Slide the instrument cluster (10849) to the right of the instrument panel opening and unhook the instrument panel harness from the back of the instrument cluster .

1. Remove the instrument cluster from the instrument panel (04320) .

-----------------------
Speedometer/Odometer Federal law requires that the odometer in any replacement speedometer (17255) must register the same mileage as that registered in the removed speedometer . Since the speedometer mileage cannot be reset on this unit, affix odometer sticker to driver's door pillar and record original vehicle mileage. Removal

1. Disconnect battery ground cable (14301) .

1. Remove the instrument cluster (10849) as outlined.

1. Remove seven screws retaining the instrument cluster mask (10890) and instrument cluster main lens (10887) .

1. Remove speedometer assembly.

Installation

1. Position the speedometer assembly to the instrument cluster back plate (10848) and install.

1. Position the instrument cluster mask and instrument cluster main lens to the instrument cluster back plate and install the seven retaining screws.

1. Install the instrument cluster as outlined.

1. Connect battery ground cable and check the operation of the speedometer .

please rate if this helps