1996 Chevrolet S-10 Pickup Logo

Question about 1996 Chevrolet S-10 Pickup

2 Answers

Where is the fuel pressure regulator located on a 1996 s10 chevy pickup

Posted by rbook851 on

Check Price eBay

2 Answers

Anonymous

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,252 Answers

where is the fuel pressure - michael_cass_619.jpgHere it is....Follow the fuel line untill you see this....

Posted on Aug 22, 2011

Anonymous

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

Should be on fuel rail on head top of engine

Posted on Aug 22, 2011

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What would cause you to lose fuel pressure while driving.

Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


0helpful
1answer

Does a 1996 chevy s10 pickup 4.3 vortec have a saftey cut off that will stop the fuel from getting into the spider injectors

Sorry there is no safety valve or switch. Only Ford products use an inertia switch.
Have you checked for power and ground at the injector connector ?
0helpful
1answer

Where is location the fuel pump relay in my chevy s10 1996

Start by resetting the INERTIA SWITCH. The location of the inertia switch will be found in your OWNER'S MANUAL. If you do not have your Owner's Manual, check online.
1helpful
1answer

Where is the oil pressure sensor lacted on a 1996 s10 2.2 Pickup

How much below 30 is it dropping? Oil pressure when in DRIVE at idle on a hot engine, is NORMAL at around 18 to 20 Psi. The warning lamp does not come on until around 7 Psi.

With that said, the oil pressure switch (for the light) is located on the lower left front of the engine. The fuel pump oil pressure switch and sender (for the gauge and fuel pump operation) is on the lower right front of the engine.
0helpful
2answers
1helpful
1answer

Chevy 1996 s10 wont start it turns but that's it we replaced the fuel pump and the crank sensor. Now what do we do.

test 1- sit with driver door open,turn key to ON not start- listen for fuel pump whine as it pressurizes system- if no whine- check fuse for ECM1 or 2,if whine check fuse for eng1 .or could be fuel relay
1helpful
1answer

Where is the fuel pressure regulator located on a 1996 Chevy Blazer with a 4.3 V6 engine?

The fuel pressure regulator is under the upper manifold assembly. disconect battery remove manifold release the fuel pressure, remove the fuel pressure regulator snap ring retainer the regulator assembly and the O-rings.
1helpful
1answer

Car starts dont run

Go to autozone, there you can rent their tool to check the pressure of your FPR. Then you should be able to connect that tool to your cars fuel line. Which will tell you the pressure.

This could and very well may be your fuel pump. Fuel pressure regulators dont go out too often.
0helpful
1answer

Fuel Pressure Regulator

not sure on an s10 but it should be close to the same position as a full size truck. Should be in the engine compartment, drivers side on top of the motor on the fuel rail. Held in by a snap ring or a c ring. When you buy your part, ask the salesman and they should be able to tell you for sure.
Not finding what you are looking for?

1,075 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85241 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22509 Answers

john h

Level 3 Expert

28546 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...