When you ask for information about your 2000 Jaguar S-Type, it would be very helpful if you would take a moment to mention which engine it is equipped with. There is a 3.0L V-6 and a 4.0L V-8 engine available for that make and model.
However, the spark plug replacement is similar except that the intake manifold must be removed to access the plugs on the right bank on the V-6 engine.
The spark plugs are located under the cover that goes down the center of each valve cover. You must remove the plastic engine cover to see the cover that goes down the center of the valve covers. Remove the screws in the cover plate. Remove the electrical connectors for each ignition coil. Remove the screws securing the coils and remove the coils. The spark plugs are located at th bottom of the hole that the coils just came out of.
NOTE: The spark plug tubes should be blown out with compressed air before removing the spark plugs. Failure to do so can cause severe engine damage from debris falling into the combustion chamber or contaminating the spark plug hole threads.
As for finding a service manual, the best recommendation I can give you is to subscribe to the service information available at ALLDATAdiy.com. This is the same infomation that I use as a professional auto repair technician. The fee is extremely reasonable - under $30 (US) per year.
SOURCE: where is the #4 spark plug located on 2000 jaguar s type?
Just follow the spark plug wires to locate all the plugs. You may hae to use your hands if you cannot actually see it. make sure the motor has cooled down first
Robert
SOURCE: how do i replace the spark plugs in a jaguar 2000?
THE SPARK PLUS ARE LOCATED UNDER THE VALVE COVERS, ON TOP OF THE VALVE COVERS THERE IS A SMALL PLATE COVER WITH 8 LITTLE BOLTS THAT NEEDS TO BE REMOVED WHICH WILL THEN SHOW YOUR COILS, UNPLUG COILS PULL COIL OUT AND SPARK PLUG WILL BE LOCATED UNDER THE COILS.
The left side is easy, just pop off the left side engine cover...remove the coils and the plugs are right there. The right side is a whole other matter completely, you need to remove the intake manifold to be to access them. It is a relatively simple job if you are even slightly mechanically inclined. Ensure you replace the upper intake manifold gaskets when you remove the intake manifold.
Testimonial: "thank you very helpful"
551 views
Usually answered in minutes!
×