Stoped to get gas when I started my 2000 saturn ls I noticed the blower was not working on any speed checked the relay and fuze both were good now what do I do?

You blew a fuse or relay. Check the fuses in the fuse panel, if those are good, check for burnt and\or "popped"-"blown" relays. Relays are usually located in a (black) box under the hood. (some are a different color, like red). Remove the cover, and on the inside (or out) you will find a diagram of the relay placement. Locate the desired relay and if it ls clear, take not as to whether its got a split in the "diode". You'll see it. If not clear, buy or find a fuse tester. Pull the relay and touch any two prongs until the light comes on, on the tester. If light stays off, the relay is bad. Chances are its simply a fuse, as fuses will blow before a relay.

The selector switch on the dash controls the blower motor relay, then the fan switch controls the speed. The fan switch gets power from a 40amp fuse and the control panel gets power from two other fuses.
If you are working the control switch to get the fan to work, the control switch may be failing.

Its most likely going to be the blower motor resistor or the blower relay. Usually the relay for the horn is the same so you can swap them; check that first. If that is to no avail then pick up a chiltons manual and locate your resistor. Good luck!!

also check the blower motor relay.


http://www.youtube.com/watch?v=wsazws_za4k

Check the blower motor to see if it is getting power,and check the blower control switch,andd it1s connector.

As long as you KNOW the starter is good, it might be a sensor that makes sure that your car is in park. Could also be your ignition cylinder (what you put your key in to start the car).

i did the same i think heres a short some where costly to fix i ran a hot wire from the battery to the motor and my switch works fine

You blower fan obviously works. Try replacing the fan speed switch.

Hello these codes do not appear in OBD 2 code retrieval book Generic or factory! anyhow sounds like you hit your speed sensor switch on your batter installation thes transmission are open space on these models I would look at this good place to start used at the end of the speedo cable is the switch!!!! good luck

You are likely experiencing vapor lock. Changing gasoline grade, or getting a vented gas cap may help.