Tip & How-To about Chevrolet Camaro

How to test a voltage regulator

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

how do i take alternaoter iot of peugeot e7

Go through few Alternator related solved Solutions including replacement of alternator.Select and Click the link below:----How to replace alternator? http://schematicsdiagram.blogspot.com/2011/12/how-to-replace-alternator-on-gmc-sonoma.html
How to test alternator on Dodge Stratus?


How to test and replace Alternator on Audi A4 Car models?



How to Remove Voltage Regulator on Car?





How to monitor Vehicles charging system? http://repairhelpcenter.blogspot.com/2011/11/how-to-monitor-vehicles-charging-system.html

Car Alternator making noise? http://repairhelpcenter.blogspot.com/2011/11/car-alternator-making-noise.html

After replacing Alternator, the battery indicator light Comes ON dash?



How to inspect Vehicles Alternator?



How to Test Vehicles Alternator?


How to Service Vehicles Alternator?


How to Replace Alternator? http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-alternator.html

Alternator testing? http://schematicsdiagram.blogspot.com/2011/12/alternator-testing.html--------- Cars electrical system is pulsating? http://technoanswers.blogspot.in/2012/01/cars-electrical-system-is-pulsating.html------ 1998 Ford F150 pickup Battery Drains overnight due to Alternator? Alternator drains car battery? http://technoanswers.blogspot.in/2012/02/1998-ford-f150-pickup-battery-drains.html------- 2002 Ford Focus sits over night and battery goes dead? http://technoanswers.blogspot.in/2012/02/2002-ford-focus-sits-over-night-and.html--------- Charging system problem on Chrysler LHS car? http://technoanswers.blogspot.in/2012/02/charging-system-problem-on-chrysler-lhs.html---------- How to replace alternator 1997 Dodge Stratus? http://technoanswers.blogspot.in/2012/02/how-to-replace-alternator-1997-dodge.html------- How to replace Alternator on Mitsubishi Lancer http://www.howtorepairguide.com/2012/10/how-to-replace-alternator-on-mitsubishi.html

These details will help.
For more help.Keep updated.

Oct 15, 2012 | 1986 Ford Bronco II

1 Answer

How can you tell if oxygen sensor is bad

Hello there and welcome to fixya
Remove the oxygen sensor connector cover and check the oxygen sensor's operational voltage. Consult your vehicle's manual to find the wiring schematic. Back probe the sensor's connector with the meter leads. Start engine again and monitor voltage readings. Voltage should switch between high and low, from approximately 0.1 to 0.9 vdc. Replace sensor if it fails this test.

Unplug the sensor connector and test the sensor's heating circuit. Using your vehicle's wiring schematic, check for 12 vdc and also for a good ground. If voltage or a ground is not present, repair circuit between connector and battery.

Measure internal resistance of the sensor's heater circuit. Check that the heater resistance is a low reading. Replace sensor if the heater resistance is infinity or extremely high.

Unplugging the sensor's connector while testing the oxygen sensor will often set fault codes and illuminate the "Check Engine" light. After all checks and repairs have been made, clear the fault codes by following the procedure in your vehicle's

Read more: How to Test Oxygen Sensors ' eHow.com http://www.ehow.com/how_4780847_test-oxygen-sensors.html#ixzz1hPBA4wKH

Dec 23, 2011 | Cars & Trucks

Not finding what you are looking for?

903 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85239 Answers

john h

Level 3 Expert

23515 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions