How to reset your service light on your honda odyssey

Hi. Here are directions to reset your immobilizer. The ignition switch has for positions. You will be using two (Accessory and Run). NOTE: Do not start the engine during the reset procedure.

NOTE: Look at your gauge cluster and identify the trip display and reset button.

(1) Turn the ignition switch to the accessory position.
(2) Set the trip reading to TRIP 1 (T1) and push and hold the trip reset button.
(3) While holding the reset button, rotate the key to the RUN position.
(4)Hold the reset button until you see the triangle in the dash flash yellow. Once this starts flashing remove your finger from the reset button. Shut the car off, verify light is out. repeat once if necessary.

Insert remote control in ignition slot. DO NOT depress any pedals. Press start/stop button once to switch ignition to position I. Press and hold button [A] 113463. Press and hold start/stop button for approximately 2 seconds to switch ignition ON. Wait 10 seconds. Release button [A] 113463 when information lamp [B] 113462 starts to flash. There will be an audible signal when reset is complete

BUTTON A IS TRIP BUTTON

1. Press and hold trip odometer reset button 2. Turn ignition key to run position KPII (not the start position)
3. Wait 30 seconds or until service light "!" begins blinking
4. Release Trip Odometer button
5. Turn ignition to off position
If that doesn't work try:
1. Press and hold trip odometer reset button
2. Turn ignition key to run position (not the start position)
3. Wait 30 seconds or until service light "!" begins blinking
4. Turn ignition to off position, the service light continues blinking
5. Release Trip Odometer button

should reset it for you

1. Turn the key to “Run,” but don’t start
2. Press “ENG MET” on the Trip
the engine.
Monitor. Then, within five seconds,
press it again.
3. Within five seconds, press and hold
“GAUGES” on the Trip Monitor. The
“CHANGE OIL” light should flash.
4. Hold the “GAUGES” button until the
“CHANGE OIL” light stops flashing
and goes out. This should take about
ten seconds.
When the light goes out, the monitoirs
reset. If the monitor doesn’tr eset, turn the
ignition off, then try again.