Service spanner

To reset the engine malfunction light disconnect the battery negative terminal for 5 Sec or more and then reconnect. Relearn the idle speed control valve. Relearn the windows.
To reset the maintenance light switch on the ignition. Bring the trip meter to A. Switch off the ignition. Press and hold the trip meter button. While pressing the button switch on the ignition and keep pressing it for 10 sec and release.

1. Make sure the trip odometer is NOT on 'Trip A' or 'Trip B' (ie: just the normal ODO). With the ignition off, press and hold the reset button. Press the 'Start' button twice without pressing the brake, but while holding the reset button. The dash will let you know its resetting, just keep holding the button until it is done.

2. Make sure the Trip/Odometer is set to "trip A". With ignition off press and hold the reset button. While pressing the reset button, press the start/ignition button twice to turn ignition on. Keep watching the trip/odometer display to flash the lines (-----) until you see it flash the zeros (00000) then it

Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds.

Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed.

Press the reset button for trip counter and keep it pressed.

Move the start switch into position "2".

Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).

To reset the service alert light, perform the following:

Within the first 4 seconds after moving the start switch to position 2, press the reset button for the trip counter twice within one second. The display for the service request is activated for about 10 seconds.

Within these 10 seconds, move the start switch into position "0". The service request continues to be displayed.

Press the reset button for trip counter and keep it pressed.

Move the start switch into position "2".

Continue to hold the reset button for the trip counter pressed until the signal sounds and the new start distance appears in the display (it takes about 10 seconds).

Hi.. after you do this step come back and rate as fixya. OK..

Turn the ignitio key to run position
Push and hold for 5 seconds the Trip reset botom.
With the botom pushed turn the ignition key to OFF position.
Keeping pushed the botom.
Turn the Ignition switch to RUN position. keep pushed the trip botom for 10 seconds or untill you see the MAINT_Requi. go OFF.

Remember all this steps with the trip botom pushed. OK.

I hope this solve your question. Thank you for use fixya.