Unless you buy a Clymer manual, free wiring diagrams are supplied in sections. In my search query add the name of the section you are looking for,

2008 pontiac g6 injectors wiring diagram

'cam sensor wiring' etc.

https://www.google.com/search?q=2008+pontiac+g6+wiring+diagram

..

Pontiac Cars &... | Answered on Jan 30, 2021

1 Answer

What those pointiac GT mean?

GT is for Grand Tourer

Pontiac Cars &... | Answered on Jan 06, 2021

1 Answer

2007 Pontiac GT G6 sedan 3.5 my headlight won't come on on the passenger side I'm just curious if there's a wiring diagram so I could see what's happening

Check bulb, fuse and relay

Pontiac Cars &... | Answered on Jan 06, 2021

2 Answers

2005 Pontiac grand Prix- won't start?? Replaced coil pack, ignition module, fuel pump, battery. Its getting fuel( checked from fuel rail) also new wires and plugs .... Im at my wits end.... Please and thanks in advance

You say you check fuel ,did you hook up a mechanical fuel pressure gauge , did you pull a plug wire an check for spark ? Is the security light on or flashing when trying to start the car ? Anti-theft system can disables the fuel injectors . Your best bet ,take your vehicle to a qualified repair shop. You don't just replace parts

Pontiac Cars &... | Answered on Jan 01, 2021

1 Answer

I have a 1997 Pontiac grand am and headlights flash on and off with the lights on or off

Most likely cause would be a faulty switch.

Pontiac Cars &... | Answered on Dec 31, 2020

2 Answers

2004 Pontiac Grand Prix pk3 relearn procedure does the starter to disable due to theft system to turn to turn off before going to step 2off before going to the second 15 minutes with Ken secL

Your doing it wrong !
30-Minute Relearn Procedure
Use this procedure after replacing the following components:
?€¢
The passkey III (PK3) keys

?€¢
The BCM

?€¢
The PCM, see important above

Important: This procedure is not available on vehicles equipped with option code (Z49).
If replacing a BCM with an GM SPO Replacement Part, perform the procedure to setup a new BCM prior to the 30-minute relearn procedure.

With a master passkey III key, turn ON the ignition, with the engine OFF.
Observe the STARTING DISABLED DUE TO THEFT message on the drivers information center (DIC), after approximately 10 minutes the STARTING DISABLED DUE TO THEFT message on the DIC will turn off.
Turn OFF the ignition, and wait 5 seconds.
Repeat steps 1-3 two more times for a total of 3 cycles or 30 minutes.

Important:

With a master passkey III key, start the vehicle. The vehicle has now learned the key transponder information and the PCM has now learned the fuel continue password.
With a scan tool, clear any DTCs.

Pontiac Cars &... | Answered on Dec 30, 2020

1 Answer

2007 G6. How can I reset traction control?

TC is a known issue. Some video help and specialist forums

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk00G6vXe1GcmC2KDTtKfW6-ItaHEsA%3A1609272543964&ei=34zrX5isOta3tQb-2b24DA&q=2007+G6.+reset+traction+control

..

Pontiac Cars &... | Answered on Dec 29, 2020

1 Answer

G6 V6. Where are relays?

It is located on the passenger side of the central console, behind the panel.

Fuse Box Diagram Pontiac G6 (2005-2010) - Fuse-Box.info

Pontiac Cars &... | Answered on Dec 29, 2020

2 Answers

2004 Pontiac grand am fuel pump location and installment

It is inside the fuel tank , to replace you would need to pull the fuel tank out of the car . Videos on youtube showing how to do it .

Pontiac Cars &... | Answered on Dec 19, 2020

1 Answer

Reseting traction control 2007 pontiac g6 3.5L

Resetting traction control message on the DIC ? Service traction control ? ETC...

Pontiac Cars &... | Answered on Dec 18, 2020

2 Answers

Which wires to bypass driver side window to go down on a 2002 pontiac Montana

You can't. The motors draw a lot of power, it has to go through a relay. Don't try and work round it, fix the issue. Go down to a local breaker if you need a switch unit.

Pontiac Cars &... | Answered on Dec 12, 2020

1 Answer

Where is the neutral safety switch located on a 2006 pontiac grand prix?

Where is the neutral safety switch located?
The neutral safety switch for an automatic transmission is located inside the transmission case or in the linkage that allows the vehicle to shift gears. This switch prevents you from starting the engine when the transmission is in any gear other than Park or Neutral.Jan 8, 2016