20 Most Recent 2000 Pontiac Grand Prix SE Questions & Answers


DTC P0401 Exhaust Gas Recirculation (EGR) Flow Insufficient - Probably has plugged passages . Take the EGR valve off the vehicle an clean the passages out .

2000 Pontiac... | Answered on Jan 19, 2019


Pontiac Grand Prix Climate Control/AC - Car Forums at Edmunds.com

forums.edmunds.com > Pontiac > Pontiac Grand Prix
Dec 29, 2007 - 30 posts - ‎20 authors Hi Joe, I had the same problem with no heat on my 2000 grand prix. .... motor and the exterior temperature sensor have both been replaced ... Pontiac Grand Prix Electrical/Lighting
30 posts
Aug 3, 2009
Pontiac Grand Prix Heater blower relay switch
30 posts
May 13, 2009
Pontiac Grand Prix Starting / Stalling Issues
30 posts
Feb 9, 2008
More results from forums.edmunds.com

Fixing AC Temperature Control on my 2002 Pontiac Grand ...

? 9:58
www.youtube.com/watch?v=2BOdhWMdxXc

Jul 13, 2014 - Uploaded by Turbo231
Fixing AC Temperature Control on my 2002 Pontiac Grand Prix... How To Install Replace AC Heater ...

2000 Pontiac... | Answered on Oct 16, 2015


Whenever you add Freon,you are suppose to leak test first.Your compressor is good,you have a leak somewhere.A good place to take it to is Midas,they changed my freon over from the old stuff to the new R-134a,they leak test it first,that is rule 1 when adding freon.

2000 Pontiac... | Answered on Jun 11, 2015


The instructions I have are 20 pages long, look in your owner's manual or maybe someone else will come up with a shortcut.

Pontiac Cars &... | Answered on Sep 06, 2020


for that youll need the service manual or a subscription to gm's website tech stuff

Pontiac Cars &... | Answered on Aug 29, 2020


5v ref goes to several different sensors. Could be a bad sensor, or wiring, or the ECM its self.

You'll need to isolate 5v ref at the ECM and then check the voltage at the 5V REF pin of the ECM with DMM. If you get 4.75 to 5.25 volts DC then likely the ECM is ok, but you'll need to load test.

If a load test of the ECM 5V REF passes then likely a sensor is bad or there's a damage wire... could be anywhere.

Try searching videos from "south main auto". Eric(?) does excellent videos explaining how to. Pretty sure he has videos specific to 5V REF.

Pontiac Cars &... | Answered on Aug 20, 2020


Utube or pinterest..or partstore freehelp. Dont git undr acar w out jackstands..ajack alone can move n fall..weargloves

Pontiac Cars &... | Answered on Aug 09, 2020


You say it cranks but won't start ? Try spraying carb. clean into the engine through the throttle plate . If it starts an dies you have a fuel delivery problem . If it doesn't pull the coils an module .

Pontiac Cars &... | Answered on Jul 16, 2020


Possibly the replacement switch is defective.

Pontiac Cars &... | Answered on Jul 15, 2020


the low side fill port is on the passenger side rear or the engine.

Pontiac Cars &... | Answered on Jul 13, 2020


check the vents/drainage slots ain't blocked. next check seals for damage/warping.

Pontiac Cars &... | Answered on Jul 07, 2020


Is the engine turning over with the key in the start position? If the engine is not spinning over and you hear a whining noise, the starter is not engaging the flywheel. If the engine is turning over with the starter engaged, the engine has most likely jumped time that creates low or no compression which results in the whining noise.

Pontiac Cars &... | Answered on Jul 06, 2020

Not finding what you are looking for?
2000 Pontiac Grand Prix SE Logo

6 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pontiac Cars & Trucks

  • Pontiac Cars & Trucks

Most Popular Question

recharged ac blew cold 1 day heard hiss

  • Cars & Trucks
Loading...