20 Most Recent 2013 Hyundai Accent SE - Page 8 Questions & Answers


Does the effect both the Front and Rear or just one? Does it work when you use the Emergency Flasher? If so, then we know that the fuse and bulb are good. If it worked with the Emergency Flasher then problem would reside in the Turn Signal Stalk or the wiring leading to it. I generally look for loose connectors or plugs. If it did not work replace the bulb. If that does not resolve the issue I would follow the ground wire from the bulb to make sure that there is a good ground. Without the ground you do not have a complete circuit.

Hyundai Cars &... | Answered on Nov 10, 2019


The service and repair manual with diagram will provide you step by step help to locate and fix the problem easily and you will get the manual from the given link https://toolsnyou.com/

Hyundai Cars &... | Answered on Nov 07, 2019


Fob didn't work so the alarm immobiliser was armed and active when the locksmith opened the car - with predictable results.

Fob still not working - broken or needs new battery. Have you fitted a new battery into the fob?

The alarm immobiliser will probably remain armed until the doors have been locked and then unlocked with the fob.

There is a small chance the system can be fooled into thinking it has been disarmed by disconnecting the battery (overnight if poss) and then with the door open and the ignition key in and turned on, when the battery is reconnected it might be possible to start the engine...

Hyundai Cars &... | Answered on Nov 06, 2019


if this is a manual transaxle the reverse lamp switch is just behind the battery box beside the slave cylinder mount. if this is an automatic transaxle it is built into the trans range switch that shift cable moves on top of transmission.

Hyundai Cars &... | Answered on Nov 03, 2019


this has two fuses for clock in under dash fuse box fuse 11 10amp and fuse 3 15 amp

Hyundai Cars &... | Answered on Nov 03, 2019


Hyundai has a tsb on this code it is 16-at-005 basically it breaks down to this: remove air cleaner find extension motor wire disconnect and measure resistance on pins 2 and 7 which if looking at male pins top row from left over 2 and bottom from left over 2 is pin 7 resistance is 112-142 kila ohms now disconnect trans temp sensor connector measure the resistance on pin 4 top row from left and pin 8 bottom row from left should be same 112-142 kila ohms at outside temp 68 . if reading are not the same resistance replace transaxle,if they both are same resistance replace HPCU (hybrid power control unit ) next step if resistance is different by 1 ohm harness is good,if resistance on both readings are different by more than 1 ohm replace extension wire . may need to send this car to dealership if this testing is more than you can provide yourself,sorry hope it helps

Hyundai Cars &... | Answered on Nov 03, 2019


That is the hydraulic tappets waiting for oil pressure. Change the oil and filter. Use only the recommended grade of oil. See your owners handbook.

Hyundai Cars &... | Answered on Nov 02, 2019


what year Hyundai? which bolts are you looking for torque settings for exactly?

Hyundai Cars &... | Answered on Oct 26, 2019


Sorry can't help with the wiring, though Autodata usually include wiring and pinouts - just wanted to mention these days a vehicle ECU is likely coded and won't work unless it is recognised by the security system.

Hyundai Cars &... | Answered on Oct 24, 2019


Go out and purchase a North American built vehicle.
Actually, it could be the connection inside of the switch, inside of the handle on the steering column.
These do wearout and do need to be replaced, the cost . . . I have no idea but it will not be cheep!
If it is still under warranty, call your dealership mechanic and ask them, there could be a recall that you have not received info on.
Good luck

Hyundai Cars &... | Answered on Oct 24, 2019


Take it back to the alignment shop and have them check for a "Torque steer" you may have a bad engine or transmission mount. I hope this helps. Take care.

Hyundai Cars &... | Answered on Oct 21, 2019


One O-ring per injector on any style injector. More than one could cause warpage of the fuel rail when the O-rings don't compress far enough.

Hyundai Cars &... | Answered on Oct 20, 2019


If you have a faulty coil, the whole coil pack has to be replaced. Not just one in the pack.

Hyundai Cars &... | Answered on Oct 20, 2019


some cars dont have a reset button, check your owners manual for info. the sensors are coming up on 10 years old. most last just about that long if your lucky

Hyundai Cars &... | Answered on Oct 20, 2019


Might be able to get key code from your VIN # .Then go to dealership if key has chip will need to be programmed.

Hyundai Cars &... | Answered on Oct 20, 2019


You probably can’t. Especially if you didn’t have the car from new. Some are permanently fixed to stop them being a weapon usable against the driver, or the front seat being used without it.

Hyundai Cars &... | Answered on Oct 18, 2019

Not finding what you are looking for?
2013 Hyundai Accent SE Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 Hyundai Santa Fe
2004 Hyundai Santa Fe

1,447 Questions

2001 Hyundai Elantra
2001 Hyundai Elantra

1,154 Questions

2000 Hyundai Accent
2000 Hyundai Accent

1,113 Questions

2006 Hyundai Sonata
2006 Hyundai Sonata

1,215 Questions

2001 Hyundai Accent
2001 Hyundai Accent

1,057 Questions

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hyundai Cars & Trucks

  • Hyundai Cars & Trucks

Most Popular Question

keyless entry operate hatch lock as

  • Cars & Trucks
Loading...