20 Most Recent 2004 Toyota Sienna Questions & Answers

0helpful
2answers

My 2004 sienna toyota van

Ome people put oil on the rubber seals around the doors. A better solution is to pick up some silicone spray and spay that on the seals. The spray can be found at automotive or big box stores (Depot).
12/24/2021 11:47:30 AM • 2004 Toyota... • Answered on Dec 24, 2021
0helpful
1answer

TOYOTA SIENNA MAINT REQD LITE CAME ON AFTER SCHEDULE MAINTANANCE

If the dealer/mechanic did the service early the light will come on when service is DUE. Go back to him and have it turned off. Search the web someone may have the procedure posted. Usually simple. Google "Toyota service light reset" or "Toyota Maintence light reset" Try this one
  1. With the car started (ignition on), set the LCD odometer readout to total mileage (not trip A or B).
  2. Turn the car off (ignition key to the OFF position).
  3. Push in AND HOLD the button/knob that switches the odometer
  4. Turn key to ON position without starting the car. You will notice the maintenance light blink and go out.
  5. Release the odometer button/knob.
  6. Turn key to OFF position.
  7. That's it! The "MAINT REQD" light has been reset to warn you to change your oil in another 5,000 or 7,500 miles or so.
10/26/2021 10:51:51 PM • 2004 Toyota... • Answered on Oct 26, 2021
0helpful
1answer

Toyota sienna not accelerating

I have a 2004 Toyota sienna some time my gas pedal wont go why can you tell me what I can do
7/30/2021 1:42:11 AM • 2004 Toyota... • Answered on Jul 30, 2021
0helpful
2answers

Same light...

That light on the toyota sienna is drumroll please,,,,,,,,,, the air in one or more of your tires is low!! It would have made more sense to have a picture of a tire or the word tire or whatever,,, not sure what that symbol actually is, but check the air in all your tires and One will most likely be much lower than the rest. The tire pressure on the sienna I believe is 35 psi all 4 tires, but you can double check by looking on your doors.
7/26/2020 5:56:50 AM • 2004 Toyota... • Answered on Jul 26, 2020
0helpful
2answers

I have a 2004 toyota

Replace your brake pads and or rotors
9/13/2019 6:36:28 AM • 2004 Toyota... • Answered on Sep 13, 2019
0helpful
1answer

How many heater sensors are in Toyota Sienna 2004

Heater sensors for what?
3/28/2019 11:17:47 PM • 2004 Toyota... • Answered on Mar 28, 2019
0helpful
1answer

2004 TOYOTA SIENNA SPEED SENIORS LOCATION, WHERE DQ I FIND IT.

https://www.youtube.com/watch?v=9dK0ajWZCIY This video will show you where the sensor is located.
3/14/2019 9:06:05 PM • 2004 Toyota... • Answered on Mar 14, 2019
0helpful
3answers

I want to be able

Fuses panels are placed in two locations - underneath the drivers side (you have to take the cover off the panel to access them) and underneath the hood.

tdisline_423.jpg
3/9/2019 1:39:58 AM • 2004 Toyota... • Answered on Mar 09, 2019
0helpful
1answer

Gear shift stuck in park 2004 sienna

check stop lamps is working. if its not working check stop fuse on fuse box located under the dashboard.
3/2/2019 3:26:10 AM • 2004 Toyota... • Answered on Mar 02, 2019
0helpful
5answers

Releasing 2005 Toyota Sienna spare tire

On my 2004 toyota,,,directly behind the passenger side front seat (have to push passenger seat all the way forward to see it, there is a small square flap in the carpet,,,lift that up and underneath is a big bolt which you turn counterclock wise with your spare tire lug wrench and the tire will lower to the ground. thats about it. good luck
6/27/2018 8:14:19 PM • 2004 Toyota... • Answered on Jun 27, 2018
0helpful
1answer

2004 Sienna - VSC and TRAC OFF Lights are On

I have both lights on in my 2004 van also I have the engine light on. i took it to the dealer and they found the Yaw Rate Sensor (Vsc & TRAC) bad. The part is about$ 405 and is under the drivers seat. The other problems is the Catalyst System (engine light) about $1000 for parts.I have about 147,000 miles on my '04 and the problems started about 130,000.
6/5/2018 8:09:49 PM • 2004 Toyota... • Answered on Jun 05, 2018
0helpful
1answer

I need the torque spec for the cylinder valve cover 2004 toyota sienna?

20. INSTALL CYLINDER HEAD COVER SUB-ASSY (a) Apply seal packing to the cylinder head as shown in the illustration. Seal packing: Part No. 08826-00080 or equivalent NOTICE:  Remove any oil from the contact surface.  Install the cylinder head cover within 3 minutes after applying seal packing.  Do not start the engine within 2 hours after installing. (b) Install the cylinder head cover with the 9 bolts. Tighten the bolt uniformly in several steps. Torque: 8.0 Nm (80 kgf cm, 71 in.lbf) (c) Install the engine wire harness with the 3 nuts. Torque: 8.4 Nm (85 kgf cm, 74 in.lbf) 21. INSTALL CYLINDER HEAD COVER SUB-ASSY LH (a) Apply seal packing to the cylinder head as shown in the illustration. Seal packing: Part No. 08826-00080 or equivalent NOTICE:  Remove any oil from the contact surface.  Install the cylinder head cover within 3 minutes after applying seal packing.  Do not start the engine within 2 hours after installing. (b) Install the cylinder head cover with the 9 bolts. Tighten the bolt uniformly in several steps. Torque: 8.0 Nm (80 kgf cm, 71 in.lbf) (c) Using an E6 torx) socket wrench, install the engine wire harness protector with the 2 bolts. Torque: 8.4 Nm (85 kgf cm, 74 in.lbf) This is year/make/model specific to the 2nd Gen Sienna. Taken from the 05 Toyota Sienna repair manual. Hope this answers your torque specs for the valve covers which uses 10 mm bolts. If in doubt, as Scotty Kilmer asserts, do a "German tight".
4/4/2018 5:10:26 AM • 2004 Toyota... • Answered on Apr 04, 2018
0helpful
1answer

Have a loud clicking noise from the front of my

You will get your solution and all info on service info, repair info, parts info, wiring/electrical/fuse diagrams, error/fault codes, torque specs, PCV, owner's/service/repair/parts/maintenance manuals etc everything this website www.reliable-store.com it's a very good website for vehicle problems even as old as 1991 ford..
3/19/2018 4:57:20 PM • 2004 Toyota... • Answered on Mar 19, 2018
0helpful
1answer

Something stuck in 2004 toyota sienna and door wont upen

Sounds like you may need to visit an authorized Toyota mechanic or your local dealer. Recommend not using it in a manner inconsistent with the designed safety functions to avoid getting someone hurt or worse. helpful-rowrfu10slju0iejfqxy2apg-3-0_0.png
2/8/2018 8:18:22 AM • 2004 Toyota... • Answered on Feb 08, 2018
0helpful
1answer

Will a faulty car battery cause the gas and temperature gauges to stop working

If a battery is below 9.6-volts or is charging above 16 -volts , you get all kinds of goofy electrical issues
2/6/2018 4:18:42 PM • 2004 Toyota... • Answered on Feb 06, 2018
0helpful
1answer

2004 Toyota Sienna XLE...overheat problem....replaced

-Are you talking about air conditioning...? -The fan works but not cold air at all ? that is what you asked? -If so. then the Freon is very low or no more. Check for leak and fix before refill Freon. Good luck Mai
11/27/2017 8:29:27 PM • 2004 Toyota... • Answered on Nov 27, 2017
Not finding what you are looking for?

1,029 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8991 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6963 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15008 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sienna Toyota

  • Sienna Toyota

Most Popular Question

toyota sienna maint reqd lite came after

  • Cars & Trucks
Loading...