20 Most Recent 2000 Toyota Camry Solara - Page 3 Questions & Answers

below the glove box behind passenger side kick panel.

e-bay motors. seller: rebuiltcars or just go to ebay and type in: 2003 Toyota Solara left driver door latch. That took me straight to it. Good luck ;0)

Hard to diagnose long distance. I would look at the throttle body and the idle air control for dirt-sludge. The control valve may be stopped up or sticking.

replace the key and tumbler

Try turning the wheel as you turn the key.

Have the idle bypass valve checked, also called idle air control valve.
If that valve is stuck in the closed position, it's not allowing the fuel to bypass the throttle plate to keep it idling, resulting in stalling, but will keep engine running if the pedal is pushed down.

I too would suspect the Idle AIr Control valve. That is becoming a very common issue these days; we replace several a month.

Low fluid in the auto or you need to get the auto serviced

Factory TDS? alldata.com or the FSM from toy. it has a "theft deterrent ECU" one clue is the 22 wire going to it, that out to lower the odds.? online at alldata.com i search for "location" and page 6, shows "transponder key amplifier", T6 about right knee in dash next brake switch. the TDS is T3/T4 id, theft det. under center console rear. or under passenger seat (LHD) cant tell by the drawing but that is 1sq area, so that close enough. working modern cars FSM free, is a hopeless thing... very very complex and lots of parts and system, mine has 14 CANBUS computers.

can i buy a question? (vanna white asks) where is.... the x where to buy x how to test. x or>?>100s more of question forms. pick one.

the cd player is busted. get it serviced. so easy,, this.... but why is running with key off, it must not be stock. huh? or the key really is not off. The rad runs off IGN1, IGN2 and ACC , and ever OFF. pull the radio fuse in main fuse box. that must kill it, (the dial light is parking. and there can be a memory wire too, that is ok, the memory wire is hot all the time, and im sure its ok)

why? you felt it , or the scan tool told you? or both? misfire, means.: that cylinder had very weak power . takes 3 things to have strong power, compression at spec. spark and fuel ratio correct. 1,2,3 any can fail, and in that order. order matters. if this is a scan tool error, DTC, post the codes, or we fail.

The new ignition key needs to be programmed to work with the immobilizer system, right now the computer is not recognizing the key because it is not programmed, you'll need to get the dealer involved to do this .

The purge valve is located under the hood near the air filter, one of the hoses has a green valve with a cap on it.