20 Most Recent
2007 Toyota Tacoma - Page 4 Questions & Answers
How do you replace a right front wheel bearing on
remove the tire
Remove the caliper- two bolts in back, could be torx or allen
remove the bracket that holds the caliper- two bolts in back
remove the rotor, with hammer if nessissary
remove the big nut holding the shaft in the middle of bearing
there are three or four bolts that are in back that hold the bearing on the spindle remove these
use a screw driver and chisel to pry the bearing out of the spindle, you will have too beat on them so use an old screw driver. If the new bearing comes with the hub, then you can beat on the hub and knock it out. be careful because your limited on space and it is easy to hit something that you don't want to hit. If the new bearing doesn't come with the hub, you will have to have it pressed out and in. about twenty bucks at a garage.
Good luck
Randy
My heater does not work
heater core might be blown-off. also see your fuses for heater under your dash fuse panel or at the under hood sometimes where they are.check your cold lever position might be at full cold counter clock wise, move it to hot position clock wise.
2007 toyota tacoma replace front wheel bearing prerunner
The other guys have never taken the wheel bearings out of a 2007 Tacoma! Remove the tire (duh) Remove the 12mm bolt holding the brake line securing bracketUn-clip the air sensor hose clipRemove the two 17mm bolts holding the brake assembly on the back sideRemove the rotor from the wheel "spindle"- slides right off.Unscrew the four metric bolts (maybe 17mm) holding the wheel housing to its mount (they cannot be removed from the assembly yet, see below).That's right there is no normal wheel spindle with a big nut on the end of a threaded shaft in the middle!The wheel mounting plate (with the 6 studs) is pressed into the bearing housing.Get a replacement bearing assembly and take it and your old unit to a machine shop (unless you have a good press).An easy job, just expensive- $140 for the bearing assembly.
Which fuse can cause it not to crank?
there is a neutral saftey switch on the clutch pedal make sure it is pressing in enough to crank vehicle these sometimes get pushed outb and need readjusted
Not finding what you are looking for?