20 Most Recent 2007 Toyota Yaris Questions & Answers

i have got it's Solution ...visit


or contact me

[email protected]

+92 302 417 4170

2007 Toyota... | Answered on Feb 03, 2020

Need a 2nz engine timing diagrame

2007 Toyota... | Answered on Dec 26, 2019

as a toyota technician, its probably the wrong fitted of the ring, once you replace the bearing they will removed the ring and in that ring there is a small hole that the sensor goes in. speedometer will not work not work if there is a malfunction in abs and it is speedometer,brake warning light are integrated with abs ecu.

2007 Toyota... | Answered on Dec 17, 2019

check your dimmer switch settings or wiggle it, if you notice a change there is you founded.

2007 Toyota... | Answered on Nov 13, 2019

get IT test from toyota [email protected] 1000/-.Tey will tell u any one or both rear sensors faulty.Get the sensor along with hub from bilalganj [email protected] 4000/ and get it changed from mechanic.Any problem contact me at email [email protected]

2007 Toyota... | Answered on Oct 16, 2019

assuming your head lights are working otherwise. I would check your DRL relay circuit. check your fuses (ecu-b & ecu-ig) are for daytime running lights. then you'll have to do a bunch of voltages checks to make sure its not the harness or a connector which I can get for you. and if everything checks out only thing left is the relay assembly..

2007 Toyota... | Answered on Jul 09, 2019

check that the cam sensor rotor is on the camshaft properly and is adjusted to the correct air gap
if the dealer just did the overhaul then take it back to them

2007 Toyota... | Answered on Mar 14, 2019

Call a key program expert. You cannot do it yourself.

2007 Toyota... | Answered on Feb 28, 2019

2007 its your drive belt,let the dealer inspect for wear or if its loose,they are not going to reproduce it they are just sending you air, but hold them accountable for the drive belt and just ask ,"hey is this belt okay and I am not going to breakdown".

2007 Toyota... | Answered on Feb 14, 2019

1 Are you recharging yourself?
2 Have you removed any previously installed components like compressor, condenser etc
In the case you are replacing any of the components you should get the oil from the parts store or it usually comes with a new compressor. I think it is about 120 CC but in case you are just changing the compressor the rule of thumb is to drain the oil out of the old compressor in to a measurable container and replace with the same amount in the new compressor. attached is a chart if any of the components have been changed and how much oil might be needed.


2007 Toyota... | Answered on Jan 17, 2019

Most likely located in a Plastic Junction box under the hood, on top of the wheelwell close to the battery, The box lid should have the fuse and relay ID printed on it.........

2007 Toyota... | Answered on Dec 17, 2018

Toyota Yaris Main and Big end Torque settings:
Tighten the main and big end bolts in sequential order and in two steps.
Main bearings. Stage 1.
22 ft lbs.
Stage 2.
44 ft lbs

Big end bearings.
Stage 1.
11 ft lbs.
Then Rotate bolt head a further by 90 degrees

Head bolt torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10

Flywheel spec:
65 ft lbs

2007 Toyota... | Answered on Nov 16, 2018

I think you could use this manual method instead.. My nephew who
is a full time mechanic uses most of the times, and all mechanics look up to manuals. It's very easy he gets it from. www.reliable-store.com

2007 Toyota... | Answered on Oct 24, 2018

2007 model Toyota cars got similar problems yet before. You must visit an mechanic to console this problem.

2007 Toyota... | Answered on Oct 22, 2018

check spark plugs for fouling and injectors

2007 Toyota... | Answered on Oct 14, 2018

If your keyless entry remote has never worked it either needs to be programmed to the vehicle or it is the incorrect remote part number for they vehicle. First step is to call your local dealership, ask for service, then verify your vehicle came equipped with the keyless entry option and verify the key fob part number. When calling the dealer have your vin# handy, they will need that. Once you have verified your vehicle has keyless entry option and you have the correct keyless entry remote part number then find a locksmith to program the remote to your vehicle. We suggest a locksmith because they are usually more affordable than the dealer and they come to you.

If your keyless entry remote has worked before and it just stopped working, here are a few tips to try to get it working again:

1) Change the battery
Batteries don't last forever, you'll be surprised how often it's just a dead battery! Search our YouTube channel on how to change a key fob battery for your specific year, make, and model!

2) Wipe the board
The board inside your remote can get a lot more filthy than you think! When the board is dirty it can prohibit the contact to the circuit board when you push down on the button. Simply wiping the circuit board off can make your key fob like new again!

3) Get it checked
Go to your local hardware store like AutoZone or Oreilly's. They usually have a RF frequency tester. This little gadget will let you know if your key fob is sending a signal. If it is, you may need to reprogram your key fob to your vehicle

4) The old car battery reset trick
I know this sounds absurd, but it works sometimes and is worth trying. If you exhausted all of the options above, disconnect both terminals on your car battery for 10 minutes. Then reconnect them and try your key fob. This has worked for many people and I have no idea why. If you do, please comment below to explain.

5) New fob!
It might be time for a new key fob! No need to dread over the expensive costs of a new key fob, at Keyless Entry Remote Fob Inc., you can get a refurbished one for a very affordable price! You won't even be able to tell the difference. Just search your vehicle make, model, and year to purchase a key fob or give us a call at 402-671-5100.

2007 Toyota... | Answered on Aug 27, 2018

I want to manual

2007 Toyota... | Answered on Jun 17, 2018

The hit may have closed a body drain. If it did this then you would have rain water collecting until it spills over. Look in that area for a plugged or crushed drain hole. That may help. Otherwise you may have to take it to a body shop to have the dent pulled.

2007 Toyota... | Answered on Jan 23, 2018

try google images for a picture of the fuse box, try ebay for an owners handbook which you may need in the future?

2007 Toyota... | Answered on Jan 15, 2018

Not finding what you are looking for?
2007 Toyota Yaris Logo

990 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Yaris Toyota

  • Yaris Toyota

Most Popular Question

fuel pump losses power after runs few

  • Cars & Trucks