20 Most Recent
2003 Toyota 4Runner - Page 3 Questions & Answers
Vsc off and vsc trac on after inspection done
Make shur your vehical is in neutral VSC is normally on in till you push the 4x4 button the VSC will turn off because your now in full time 4x4 , when you push the 4x4 button again the VSC should automatically turn back on without notifying you on your dash board.
Brakes Problem
hi there. the abs is a very complex system and is not something that
can be done. on a diy basis. there is to much to it. sensors valves.
and electrics. you could spend weeks even months and get nowhere.
best solution is the professionals. hope this helps.
Tensioner pulley won't turn
- non original part you're using?
- I assume so - lot cheaper
- might have to space it so it doesn't jam anymore - watch for right belt drive after so
if the original is still in there and jams - you're up for a new one first
B1181
I have the same code B1181 open circuit in switch B (second phase)
Can anyone help me?
Instructions above are disable to open..
Thanks in advance
Ligths on vsc and track off
did you read the operators guide yet, it answers that.
all cars made with VSC.
it will say,driving wrong or there is a problem with the system.
if not driving wrong, then take it to the service shop for tests.
read the wiki on VSC, learn what it does.
it can be normal or bad.
not reading the operators manual on this invites, danger to you and others. read it.
the lamp does have messages to you, on , off, flash etc.
How do I reset my 4runner airbag light
That all depends on why the light is on. You'll need a scan tool to pull the code. It either needs a zero point calibration or there is a short/open in either the wiring or a component. The most likely problem is an open in the spiral cable or wiring under a front seat.
Not finding what you are looking for?