Top 20
2006 Fiat Strada Questions & Answers
How to remove a broken window mechanism in a Fiat Strata Bakkie
To get to a window mechanism, the inside panel has to be removed. Locate all screws that hold the panel handle and any other part of the panel to the door frame. The sides and bottom of the panel are held in place by panel retainers , which pop out of the door frame. Place a panel tool or flat screw driver along the sides and bottom to pop out the retainers. Once the sides and bottom are free t, the top of the panel should lift up out the track on top. Be careful of any wiring before you remove the panel.
Timing belt
Do not panic until you have a compression test done. If the valves continued to work and I suspect that was the case then there should be no problems. Just have the compression test done first.
Timing marks
timing marks are typically on the crank pulley, without knowing what vehicle it is, look around the water pump. sometimes, there is a gap behind the water pump where you can see the marks. either way, they should be on the crank pulley.
What is a schrader valve
Usually its the valve where you add freon to the ac, or check the fuel pressure on a fuel injected car.It looks like a tire valve.
My fiat strada does
check for spark problem could be faulty ignition system or idle speed control.
I changed the cat
have you reconnected the O2 sensors 2006 it will no doubt have two sensors one before the cat and one after
Car won"t start ,icon for
You have lost the CODE in your Key or your Ring has gone bad and has to be replaced. Sometimes you can bring it back to the dealer (They are the only ones who can re-program a key) and see if they can do it.
Hopefully you are somewhere that still has a Fiat Dealership
Hi i have a pontiac
Unfortunately, code "1040" is a generic fault code and may need further diagnostic testing to decipher. In some cases, special diagnostic equipment may be required. If the code begins with a letter "P", for example, this indicates a powertrain problem.
Had this been code "P1041", for example, this would mean that injector circuit #1 is malfunctioning. P1042 is injector circuit #2, and so forth.
Have a great day !!!
Not finding what you are looking for?