20 Most Recent 1990 Daihatsu Rocky - Page 8 Questions & Answers

hello sir, ryobi trimmers and other models removal of the bell housing,removal of the metal bell housing,or clutch drum, on models 780R & 790R, here is what you do. after removing the trimmer & shaft assembly.remove the spark plug insert a screwdriver in the cylinder to keep piston from moveing. to remove the bell housing twist off the spring and using a T20 TORX screwdriver unscrew the retaining screw in the center of the bell housing (normal r/h thread) . push down firmely try not to strip screw head . you should be able to remove clutch housing.remove clutch using a pair of channel locks,works for me, (normal r/h thread) you should be able to remove front engine cover to repair what you need to.coil,pull stsrt, hope this works,. this solution applies to all trimmers with clutch removal~~~hope this helps,,any comments welcome,thank you. ``

Daihatsu Rocky... | Answered on Feb 18, 2012

Hello and welcome to FixYa!
You may want to start on spark plug replacement. If the spark plug has big gaps, corroded, covered with carbon or just faulty it can misfire. There's fuel but not enough current to burn it that's why it misfires. I believe you'll be good after the spark plug replacement. If problem still persist please keep me posted.
Hope this helps and thank you for using FixYa! Have a good one!

Daihatsu Rocky... | Answered on Sep 11, 2011

You have blown the fuse for the cigar lighter when you used the air pump. It will likely be a 25 or 30 amp fuse in the passenger compartment fuse box that is blown. If you don't have an owners manual buy a cheap 12 volt test light and probe the sides of the fuses with the key in the off position, if you find a fuse that lights only when one side is touched that is the blown fuse.

Daihatsu Rocky... | Answered on Aug 17, 2011

it is usually under the dashboard on the drivers side, it may be a round or square unit about 2" long with a connector plug on the top.....hope this helps......cheers.

Daihatsu Rocky... | Answered on Jun 26, 2011

I don't have a very good description of what part you are working on, but sounds to me like you are either removing an engine or transmission and you are probably looking at a dowel pin. There are usually 2 in either the engine or transmission and they help to line everything up during reassembly.

Daihatsu Rocky... | Answered on Jun 10, 2011

Ok....let's start at the beginnning a little bit......have you voltage tested the alternator whilst the car is running.....it should be between 13.8-14.2 v

Daihatsu Rocky... | Answered on May 27, 2011

Not finding what you are looking for?
1990 Daihatsu Rocky Logo

132 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Daihatsu Experts


Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

6517 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Rocky Daihatsu

  • Rocky Daihatsu

Most Popular Question

lost combusting two cylinders not oil

  • Cars & Trucks