20 Most Recent
1990 Daihatsu Rocky - Page 4 Questions & Answers
1 Answer
How do I install a timing belt on a 1990 Daihatsu
If you go to warfs.org and join the free site you can pull up free manuals it has the complete step by step instructions, I just pulled it up yesterday for my 90 rocky. warfs stands for worldwide association of rocky and feroza owners, and once again it is free.hope this helps you
1990 Daihatsu...
|
Answered
on Jun 04, 2010
2 Answers
I have a 1994 daihatsu
Why not ask your mechanic - he will be so happy to tell you or even get the parts for you. Mechanics are a friendly lot when given the chance. Think of him like a Den Mother - always at the ready to help.
1990 Daihatsu...
|
Answered
on May 10, 2010
2 Answers
How do I remove the rear brake drum on the 90
after removing the wheels, it should just slide off. If you have a ridge on your drums this might not be possible. You can try to install two bolts into the small bolt holes on the drum. Turn these bolts together as much as possible and it will force the drum off. Like I said though, if you have a ridge on your drums you will have to back off the star adjuster located inside the brake drums. To do this, there is a small inspection hole on the back side of the drum. There should be a small rubber cover shaped like a large horse pill. Oval in shape. Remove this and you will have access to the adjuster. Using a flat blade screwdriver, pry the gear shaped wheel until the shoes of the brakes are adjusted in far enough to bypass the ridge on the drums. This combined with the two bolts should release the drum from the axle. Good luck.
1990 Daihatsu...
|
Answered
on Feb 04, 2010
1 Answer
Engine keeps cutting out , like its a fuel problem
It's most likely drawing air around the fuel filter housing. To check it take the two off the top of the filter housing and joint them together giving it a direct feed from the tank to the pump. Start it up it should run fine. If you have been working at the fuel filter before you had the problem then you may have put the pipes back wrong way round this will cause it to idle and not rev. up as well.
1990 Daihatsu...
|
Answered
on Oct 16, 2009
1 Answer
We have a daihatsu rocky 4 x 4 independent. having
ensure trans is in 4h and lockinghub control handle is in FREE position. raise vehicle and remove front wheels. remove caliper and locing hub cover. remove snapring and locking hub. remove outer wheel bearing lock nut,lock plate and adjusting nut. remove bearing and disc. remove oil seal from hub and remove inner bearing.
1990 Daihatsu...
|
Answered
on Jun 24, 2009
Not finding what you are looking for?
