20 Most Recent
2002 Hyundai Santa Fe Questions & Answers
Where is the starter located
if you follow the positive+++ lead from battery it will lead you to starter located at back of engine nearest the bulhead make sure you remove/disconnect the battery earth lead 1ST b4 you commence work also if radio is code type ensure you have code for rest after work done out of curiosity?? what are you needing starter location for ? we may be able to help you with problem ? b4 you start or renew starter unnecessarily ? just a thought ??
How to drop the drive shaft to get to the vapor canister to replace.2002 Hyundai Santa fe AWD GLS MODEL
Exactly which driveshaft do you mean? The one that goes front to back, (prop shaft), or the driveshaft going to the actual wheel?
If you are going to remove any of the drive/prop shafts you will need to drain the transmission oil. This will stop it dribbling all over the floor when the shaft comes out of the transmission! REMEMBER to Refill the Transmission BEFORE you drive it!
The 'prop shaft' is the easier of the two to remove BUT they are VERY heavy so have someone help. One end is fastened to the Differential flange with 4 bolts, the other sliding on a splined shaft at the transmission end.
Driveshafts to the wheel are a lot more work. You have to strip the lower half of the suspension to get the shaft out and the 'castle nut' at the hub end can be very tightly fitted.
Alarm goes off continuously
Hundai Santa
insert manual key into drivers door...turn clockwise and hold for 3 seconds.. then turn key counterclockwise and hold for 3 seconds... this resets alarm system.
How to tighten brake cable?
Rear of interior console between the front seats.There should be access to the adjustment nut on the cable running up to the ebrake assembly.
2002 Hyundai Santa Fe won't shift out of park
If holding the brake on does not release the shift interlock,you may have a bad brake switch or shift interlock solenoid.If you can get access to the shift solenoid (usually at the base of the shifter) you can just tie it in the off position if needed.
Not finding what you are looking for?