20 Most Recent 2000 Daewoo Leganza - Page 7 Questions & Answers

remove radio and obtain serial number from decal on the radio chassis. Email DaewooUSA with the radio number and VIN number of vehicle and they will supply code to unlock radio.

remove the radio from the dash and attched to the radio chassis is a code number decal. Email DaewooUSA with your radio code and VIN number. They will supply the radio code

although the ABS uses the brake system it functions independently and is comprised of mostly electrical components. Worn brake pads will not effect the abs systems function.

What you need to do is have the ABS system scanned for codes. This will give you a much clearer idea of the direction to go in order to solve the problem. Since the light comes on and stay on after you start the vehicle the ABS system has a failure in its self check. Common causes of this are bad wheel speed sensors but there are numerous other possibilities.

If you have an ohm meter you can check the resistance of all the wheel speed sensors. if one is not simular to the others than that would be a good place to start. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

its probally your starter....go to autozone they can test it without taking parts off

Could be brake switch, Located on the brake pedal. Or the solenoid for the shifter. Located on the shifter Brake switch is cheap, solenoid is not.

OBD Code P0118refers to,
The engine coolant temperature (ECT) sensor is a thermistor screwed into a coolant passage in the cylinder head. Sensor resistance is high when coolant temperature is low and resistance drops when coolant temperature increases. The powertrain control module (PCM) provides a 5 volt reference and a ground to the sensor. The PCM monitors voltage drop to determine coolant temperature. If the ECT reads less than freezing temp. when engine has been running for more than a few minutes, the PCM determines a circuit fault and sets this code. Or if the PCM determines the sensor resistance is out of specs, this code is set.
I hope this helps.

When the check engine light flashes on a vehicle that is a sign to have it checked asap. You should get it in to someone who has a scanner to find out why it is flashing!

contact daewoo and they will order one for you

They mean to turn the ignition key from lock to run (don't turn it all the way to start) and back to off a few times. It's like restarting your computer after installing updates. Or you can unhook the negative battery cable for a couple of minutes to clear the codes from the computers memory.

The fuse box is located under the dash, left hand side. Slide the panel open and the diagram is on the inside of the panel.

you can download the manual by searching online for auto manuals. The download I used was like 48 pages of information, all free of course.

its not necessarily the head gasket. it could be the trans fluid cooler in the radiator. youll need to replace the radiator or run a separate cooler

need to deal with a dealer codes for radio are a [security ]part of anti-theft systems dealer has access to code usually dont charge for code

Thanks for choosing FixYa and welcome. You need to find the leak. If it is coolant leaking, this is your problem. If it is inside the engine, it will be a hard fix. If not, check all the hoses. Check your level of coolant fluid. If it is a slow leak, might be able to add coolant so often to keep it cool. Make sure your fans and radiator are working. A sticking or bad thermostat is the most common issue for overheating, followed by the water pump, valve, and impeller. If it is a bad leak, it will cause overheating. If you are low on coolant, same thing. If you have a question, let me know.