20 Most Recent 1992 Hyundai Excel - Page 4 Questions & Answers

by the sound of it you need to adjust the clutch to obtain the correct amount of free play,if you do not have the right amount of free play the clutch plates will drag and cuse the car to try to move with out any gas

HI
DID YOUR CAR WONT START ????
IT WELL COME WHEN START BECAUSE THE (ECU )RECEIVE THE START SIGNAL ??
BUT IT WAS NEED THE (CKP)SENSOR SIGNAL TO START IT IN RUN ??
CHECK FOR THAT !!
ASK ME FOR MORE AFTER CHECK ??
WITH MY BEST WISHES

it sounds like the memory wire isnt connected to the correct position the memory wire on the stereo needs to go to b+ also a faulty battery can cause this even if the battery can still start the car. an auto electrician should be able to test the battery for free to eliminate that as the problem

Start the car and disconnect one of the terminals on the battery, while the car is running, if the cars is still running after you disconnect that terminal then your altenator is working properly. If the car shuts off, then you will have to replace your altenator.

check other fuses

A badly worn clutch, misadjusted clutch can cause that.

look under the rear seat. there might be a plate to get to it.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manu als

Check your engine oil cap and see if the inside of it has yellowish gooey & slimey build up in it. If so you coolant is leaking in to your engine oil

Sounds like the fuel pump is failing. I would check the fuel pressure to make sure it is within specs, call dealer or parts supplier for specifically for your vehicle, for example some vehicles require 45-56 psi. If it falls below threshold, the pump is faulty and needs to be replaced. I hope this helps you get going :o) Jesus loves you, John 3:16-17 (KJV)

Have the vehicle scanned by a reputable shop right away. Driving the car the way you are WILL cause the transmission to fail and you will need to have it rebuilt. A good shop will have a scanner that will check for any trouble on the transmissions sensors. If all that checks out, you will need to have the unit rebuilt.

Wiring, schematic, electrical diagrams etc are basic contents of these online books they sell here on this website link I have attached. Must check it out

Easy problem. Check your clutch fluid (it is most likely low) master cylinder on the front of the gearbox most likely has failed, causing you to try and put it in gear, but then you broke the shifter cable. Easy fix.