20 Most Recent 2004 Land Rover Range Rover Questions & Answers


two videos for you

  • How to reset the air suspension inactive warning Range Rover www.youtube.com/watch?v=xR899nhkRxE
    • BY POWERFULUKLTD
    • 56 SEC
    • 290K VIEWS
    2010-11-11 · Video embedded · Air suspension inactive reset, ... How to reset the air suspension inactive warning Range Rover ... Wabco Air Suspension Compressor ...
  • Air suspension inactive problem range rover - YouTube www.youtube.com/watch?v=sv5nuKb10Ew
    • BY MMMZZZHHH
    • 52 SEC
    • 26K VIEWS
    2014-03-31 · Video embedded · Air suspension inactive problem range rover ... Wabco Air Suspension Compressor Repair Kit for Range Rover - BMW - Land Rover - ...


  • and some text for you.

  • Thread air suspension inactive

    2004 Land Rover... | Answered on Mar 02, 2020


    Remove the inside trim and undo the mounting screws. Suggest you do not try to adjust the internal parts of the mirror because it is inevitable to mirror will not want to go back into its designed position. Better to find a replacement unit

    2004 Land Rover... | Answered on Nov 03, 2019


    You need an owners manual or access to factory
    manuals to find out how many fail safes your vehicle has

    Example: Electronic Throttle Control
    Engine Over Temp
    Transmission Failsafe
    Misfire Fail safe to protect converter

    Once you have checked for codes which I assume you have
    done long ago,you use them as well as trouble charts to
    diagnose things

    2004 Land Rover... | Answered on Apr 30, 2019


    It depends on what you mean by electronic thermostat wire. I assume you have the L322 Range Rover with the BMW M62 4.4 litre V8 petrol engine. It has a heater in the coolant thermostat which causes the thermostat to open further when the engine gets too hot.. The wiring to this often fails due to coolant leakage into the cable. Disconnecting it will make no difference to the running of the engine. (On mine, it has been disconnected due to corrosion).

    2004 Land Rover... | Answered on Apr 30, 2019


    SIMPLE SOLUTION :
    Turn engine on, without moving the car, turn steering wheel from one extreme side to another 4 times, message "air suspension inactive" should be over now (; ])

    2004 Land Rover... | Answered on Feb 04, 2019


    Air Suspension Inactive usually means there is a problem with the Air Suspension. However, it will also come up when alternator or battery voltage is low, or when you reset (disconnect and then connect) the battery. To reset it manually: while in P(ark), turn steering wheel all the way left, hold few seconds, and then all the way right, hold few seconds. All the warning lights will go out. Most common failure is the passenger front air strut, since batteries are prone to leaking acid, it leaks right on top of the rubber airbag and burns through it. Dealer willcharge you one hour to diagnose, or you can easily diagnose this by looking at the ride height of each particular corner of the truck. If its sits low, or emits hissing sound when you park the truck, its leaking. If you keep driving with leaky air strut, you risk burning up the air compressor, as its working extra hard to compensate for the leak. Replacing the strut is easy 45min job even for a novice mechanic, and you can do it yourself. Strut can be found new for approx $750 online. If you are fed up with air suspension issues, there is a $700 kit that converts the truck to springs, and disables all of the air suspension. Look up Arnott Industires

    2004 Land Rover... | Answered on Dec 28, 2018


    1 Check for the "Remote Battery Low" signal message that is displayed on the vehicle's dash once the remote key battery starts to run down. Be sure to replace the battery is before it dies completely. If the battery is dead, it will not be able to start the Range Rover.
    2 Buy the correct battery for replacement. Two round CR 2025 batteries are needed. You can purchase them at most major supercenters, camera stores or **** stores. They are a common size and should be readily available.
    3 Use a nickel to remove the battery holder on the key remote. Turn the cover until the arrows line up and remove it. The cover fits very tightly and you may need a small screwdriver to pry it off. Remove the battery holder and circular ring from the remote. Take the old batteries out of the battery holder.
    4 Place the new batteries in the battery holder. Replace the battery holder and circular ring in the key remote, aligning the arrows. Turn the cover clockwise until it is secure.
    5 Resynchronize the key by simply placing the key in the door lock. Lock and unlock the door to the Range Rover and then press the remote control.

    2004 Land Rover... | Answered on Dec 18, 2018


    I would have my fuel pressure tested to make sure the fuel pump did not fail

    2004 Land Rover... | Answered on Dec 18, 2018


    The 'Trans. Failsafe Prog' display indicates a general fault within the trans and this should leave a fault code which can be read off to pinpoint the exact transmission problem. Without this code it will be difficult to correctly identify the source of your problem.

    Drop the trans pan and check for debris -- if you have metal in there, then you're going to need a rebuild.

    2004 Land Rover... | Answered on Dec 18, 2018


    Replace the battery. I had issues with transmission and air suspension despite the battery holding charge. New battery fixed it

    2004 Land Rover... | Answered on Oct 17, 2018


    you may broke a piece of fine or rail off in the hole. look in the hole for obstruction , if there is , use a paper clip to remove it

    2004 Land Rover... | Answered on Feb 02, 2018


    From the sound of it you have used a bunch of cowboys to do the work. If the gear shift is operating, the problem must be in the linkage.

    If this mob can't find it, get the vehicle towed AT THEIR EXPENSE to a Land Rover specialist or failing that to a auto specialist.

    Meanwhile, I'll check with my own specialists to find out if this problem has ever happened for them

    2004 Land Rover... | Answered on Nov 29, 2017


    Rear compartment, right hand side.

    2004 Land Rover... | Answered on Sep 13, 2017


    Is the buzzing when you insert the key related to the steering wheel adjustment?

    Re the sensors, has the button on the centre panel which turns the sensors off been pressed? Is the light in the button on or off?

    2004 Land Rover... | Answered on Sep 13, 2017


    to get rid from your problem i suggest you to visit once on the link given and you will get the solution http://toolsnyou.com/

    2004 Land Rover... | Answered on Aug 14, 2017


    You might need to reset your fob , go onto youtube and should show you what to do , ps does with most cars good luck colin

    2004 Land Rover... | Answered on Jun 19, 2017


    first up get advice from accredited professionals--relations are seldom qualified to help
    have the fault codes read to determine where the faults are to eliminate guessing and wasting money
    ECM rarely go bad but the CPU program can be corrupted from removing the battery or letting it sit flat battery
    That problem can be fixed using the same scan tool the reads the fault codes

    2004 Land Rover... | Answered on May 07, 2017

    Not finding what you are looking for?
    2004 Land Rover Range Rover Logo

    566 questions posted

    Ask a Question

    Usually answered in minutes!

    Top Land Rover Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    Marvin
    Marvin

    Level 3 Expert

    85239 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8984 Answers

    Are you a Land Rover Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    View Most Popular

    Range Rover Land Rover

    • Range Rover Land Rover

    Most Popular Question

    resetting radio range rover vogue 04

    • Cars & Trucks
    Loading...