Top 20 2004 Infiniti G35 Sport Coupe Questions & Answers

well you can put key in door turn to lock hold few secs to see if that will move window up. try helping glass up, if does not move at all then not training issue, if moves part way then retrain it.

There should be manual release cable inside the trunk behind the trim panel near the gas door location.

The dealer or a reputable independent repair shop that works on high end Japanese cars. The shop will only update the computer if there's a software update that pertains to your particular problem. Find an independent dealer shop: iatn.net

Check the battery cables and battery to starter cables for corrosion and tightness .

Only Ford products have that switch.

Blown fuse or bad switch. Turn on lights and check for voltage at each light socket

I am having the same problem. My brake lights work but my taillights do not and I don't know what to do I have changed all the fuses under hood and by the brake pedal PLEASE PLEASE PLEASE LET ME KNOW IF YOU FIGURE OUT WHY my car is 2004 g35

code p 0327 refers to knock sensor (KS) 1 bank 1---low input===causes ---insecure KS, poor connection---wiring short to ground---incorrectly tightened---KS---ECM check all the wires for good connections and the fitment of the KS replace the KS if all other items check out ok

caliper may be starting to seize.

the alarm will be deactivated by key in door lock unlock, the no start is not alarm, check security red led is on, indicating key programing needed

No, all of them run off one circuit breaker. If the window doesn't work with the master or rear window switch, replace the window regulator and motor.

check in your owners manual first if not try google for the information

bad relay

Owners Manual That is where you go for fuses & lamps There is next to no chance you have a fuse issue If a fuse is involved, I doubt replacing it will do a thing They blow for a reason Access the lamps,most likely burnt out

It's most probably the wear indicators on the brake pads. They make an irritating low pitched intermittent squeal or groan each time they contact the turning rotor. The noise goes away when you step on the brakes. Check the pad wear by pulling off a wheel and looking through the slot on the circumference of the caliper. You should have even wear on both pads, and at least an eighth of an inch of pad left. If not even you'll need to pull the caliper, and clean and lube the pins it slides on. If worn or uneven, replace them; it doesn't pay to try and wait for pads to wear down any farther, because you'll probably end up scoring the rotor.

coin stuck

Automatic or Manual?

Your camshaft sensor is shot. I had the same problem on my 03 coupe. There are two camshaft sensors. They are located on the back side of each cylinder head. My 1st one went out and I replaced it and then the other went out about a week later. The sensors cost roughly $70 each and aren't that difficult to change. Hope this helps.

P0340 Infiniti - Camshaft Position Sensor Circuit Bank 1

you do not provide enough information to answer this is your battery fully charged? has it been LOAD tested? do you have a security system disabling the vehicle? do your lights and power accessories work properly? how do you know your starter works if the car makes no noise?