20 Most Recent
2004 Hyundai XG350 - Page 6 Questions & Answers
Where is the fuel filter located
Generally speaking, the fuel filter on Hyundai cars is in the fuel line, near the gas tank, on the driver side.2004 is when Hyundai dropped the replaceable fuel filter on most models. So it may not have one outside the gas tank.
I need 2004 Hyundai XG350L Service/repair Manual
3.5L Engine
Remove or disconnect the following:
-
Negative battery cable
-
Engine coolant
-
Water pump pulley bolts
-
Alternator bolt, loosen only
-
Water pump pulley and drive belts
-
Crankshaft pulley
-
Timing belt cover(s)
-
Turn the crankshaft until the timing marks on the camshaft sprocket and cylinder head are aligned.
-
Loosen the timing belt tensioner bolt and turn the tensioner counterclockwise as far as it will go. Tighten the adjusting bolt.
-
Mark the timing belt with an arrow showing direction of rotation.
-
Remove the timing belt.
-
If defective, remove the timing belt tensioner.
Timing belt sprocket alignment mark positioning for belt removal and installation—3.5L engine
To install:
-
If necessary, install the timing belt tensioner.
-
Attach the top of the tensioner spring on the engine coolant pump pin. Ensure the hook on the pin is facing down and the hook on the tensioner is facing away from the engine
-
Rotate the timing belt tensioner to the extreme counterclockwise position. Temporarily lock the tensioner in place.
-
Align the timing marks of the camshaft and crankshaft sprockets.
-
Install the timing belt on the crankshaft sprocket, then onto the rear camshaft sprocket.
-
Route the belt to the coolant pump pulley, the front camshaft sprocket and the timing belt tensioner.
-
Apply force counterclockwise to the rear camshaft sprocket with tension on the tight side of the belt and check that timing marks are aligned.
-
Loosen the tensioner bolt 1–2 turns and tighten the timing belt to a tension of 57–84 lbs. (260–380 N).
-
Turn the crankshaft two turns clockwise.
-
Readjust the sprocket timing marks and tighten the tensioner bolts.
-
Install the timing belt covers.
-
Install the crankshaft pulley and tighten to 108–116 ft. lbs. (150–160 Nm).
-
Install or connect the following:
-
Timing belt cover(s)
-
Crankshaft pulley
-
A/C compressor belt
-
Water pump pulley
-
V belt
-
Negative battery cable
-
Engine with coolant
How do you fix code 1155 on a 2004 Hyundai xg350l
Hi there:DTC P1155 - A/F Sensor Heater Circuit Malfunction(Bank 2 Sensor 1)This is a very common code and the front Air Fuel Ratio sensor located in the front manifold will need to be replaced and the codes cleared. Here is a very similar pic to your vehicle...
This is a V6 car so it has 2 heads. They classify Bank 1 as having cylinders 1,3 and 5 while Bank 2 has cylinders 2,4 and 6. The same would be for a V8 engine. 4 cylinder engines only have Bank 1...
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa.
Check engine light is on
Check Light have been on all vehicles since 1983some 30 yearsSo what possible question could you haveYou surely know about checking for codesIf you don't know or work on car they who careslet a repair shop tell you what they think is wrongJust don't authorize any work or repair until you actuallyreturn to the shop in person & get an eduction an the current problemDo not believe half of what your told,actually gothere & ask the questions & be shown how the testresults were derived
Not finding what you are looking for?