Top 20 2000 Land Rover Discovery - Page 5 Questions & Answers

If you're standing looking at the rear of the vehicle, it's on the chassis rail on the right hand side rear wheel arch.

2000 Land Rover... | 1,062 views | 3 helpful votes

yes there is a pressure sensor. check freon level first.

2000 Land Rover... | 230 views | 1 helpful votes

Behind the off side rear wheel if its diesel

2000 Land Rover... | 79 views | 0 helpful votes

check ur thermostat its not opening to let heat pass through

2000 Land Rover... | 435 views | 1 helpful votes

What electronic gearbox ? there will iether be a manual transmission ( thats where you can change gear using a clutch, thats the extra pedal on the left) or you have an automatic transmission( thats where you have a lever thats allows you to put it into R, D etc and DOES NOT have an extra peda) these gearboxes are not electronic, they are driven by oil pressure. What will you do when you find the ........ gearbox ?

2000 Land Rover... | 161 views | 0 helpful votes

There are two, one pre-cat, one post-cat! Both need a 22mm crowsfoot spanner, and care must be taken as they are easily damaged by dropping, excessive heat or contamination.

2000 Land Rover... | 204 views | 0 helpful votes

Well, remembering that the head bolts are stretch bolts, which you tighten to 20nm (15lbf.ft) then turn 90 degrees, then a further 90 degrees :)
The inlet manifold you initially tighten them to 10Nm (7lbf.ft), then it says for the gasket clamp bolts you do those to 18Nm (13lbf.ft) and finally to 51Nm (38lbf.ft)

2000 Land Rover... | 200 views | 0 helpful votes

Suggests either Wheel Bearing, ABS Sensor Fault, or Shuttle valve. Best to get it to a dealer and on the computer for them to diagnose what exactly is wrong.

2000 Land Rover... | 872 views | 2 helpful votes

u will need to consult a transmission shop to have some test run to pinpoint that

2000 Land Rover... | 121 views | 0 helpful votes

The sensor can be faulty. It's about £25 to replace, or you can just disconnect it IIRC. Defender TD5's don't have it fitted!

2000 Land Rover... | 238 views | 0 helpful votes

you need the code to reset it ,on this model their is a code that you can use where you turn the key so many times to the left and right in sequence .ask at the dealers

2000 Land Rover... | 780 views | 0 helpful votes

sounds like when the pads where changed like maybe a wheel speed sensor was unplugged or damaged. return it to whomever did the repairs and let them find it. if it was you then you need to remove all the wheels and inspect for loose connections or broken wires,

2000 Land Rover... | 247 views | 0 helpful votes

before you remove any parts,find the timing mark and point it together to align

2000 Land Rover... | 110 views | 0 helpful votes

Remember the head bolts are not reusable. They are stretched, not torqued. I can't post illustrations here but the pattern can be found at LR’s service website, (you can register for free). The bolts are tightened to a light torque of 15 foot pounds, then turned through two angles of 90 degrees each.

2000 Land Rover... | 262 views | 0 helpful votes

for over heating it is not necessary always that head leakage is the problem, it could be radiator fan not working, first check this with technician, might be the fuse problem. don't worry.

2000 Land Rover... | 120 views | 2 helpful votes

You meant the wiper do not park? That is a problem with the motor assembly, which is responsible for parking the wipers. The switch just turns it on, and off.

2000 Land Rover... | 922 views | 1 helpful votes

check the fuse, for the unit,first

2000 Land Rover... | 152 views | 0 helpful votes

Probably more likely to be oil in the injector loom. About £35 for the part and an hour or so to replace.
Easy way to check, get the ECU out from under the bonnet by the jack, unplug IIRC the red plug and see if there's oil oozing there. If there is, get some contact cleaner and clean that up, but odds are the upper loom has a failed o-ring. This can be replaced then cleaning the lower loom at the ecu a couple of times a week can clear the rest out negating the need for a engine loom replacement.

2000 Land Rover... | 267 views | 0 helpful votes

Not finding what you are looking for?
Cars & Trucks Logo

281 questions posted

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Discovery Land Rover

  • Discovery Land Rover

Most Popular Question

2000 land rover discovery 2 sd model

  • Cars & Trucks