1994 Eagle Vision - Answered Questions & Fixed issues

hello ,, its or the wiper motor ,, or the delay relay of the wiper motor

Hello , for heater core or AC evaporator ,, you have to remove the dashboard to reach the housing and replaced them .. no other way

EGR valve may be stuck closed allowing pinging . The Knock sensor can also go bad and not retard timing allowing pinging also . Heavy carbon buildup in the combustion chamber can increase compression causing pinging .

Check transmission fluid level according to your Owner's manual. no manual? try filepeep.com if they have it or manualslib.com or a repair manual from your favorite auto parts store.

It will have a 2 prong electrical connector and be in the shape of a bolt/nut head and screws into the transmission

there is a relay not a fuse for them look under the hood in the fuse block make sure you are getting power to them they both work on the same relay could be a bad ground

screwdriver

the eagle is the worst car on the market, that is why you have it

chnage the modulator

vacuum or trans is bad

Look for all of your answers on youtube this site in not good for all of your problems

I do not think that this is your problem ,if you smelled some wires burning you had a short under the dash or something , I very rarelly seen clusters go bad find your short first , this may also be why your lights are not working right either

there is no reset switch on the fuel pump , what is it doing if your car is not starting because of fuel problem you pump is bad , it is in the gas tank ,before you change it get your fuel pressure checked on the fuel rail this will tell you if it is good or not

go on youtube and post your question it is easy to ck you can make your light blink and they are the codes

you may need to replace the hevac modual located behind the glove box ,

The pump is mounted inside the fuel tank. This a complete assembly with strainer & such, available at most parts stores.

Not only does the Oil light come on when it is low, it will also come on when the PRESSURE IS LOW or if the Pressure Sending Unit has gone bad or is DIRTY.a. If you keep driving it, you can blow the motor if it is low oil pressure.b. If it is low pressure, it could be due to blockage of passages or worn parts.c. You can add Diesel Fuel (1.3 quarts to your Oil, do not drive it but let it idle for 15 mins... Drain the Oil and add a thicker oil (20w-50) and see if the light goes out.d. Put a Gauge on the Engine and check the Oil Pressure. If it is low, and the oil increase to 20W-50 or 40 weight does not help... you are looking at pulling the engine.e. If the Pressure is normal, I would replace the Oil Pressure Sending unit.Good Luck

-Possibly oil presure sensor is faulty. (Or it stuck in low position)Mai

Fix what -- a rusted brake tubing ?You have to buy tubing at the auto partsstore & then have the tools to cut,bend ,flair & fabricate what your replacingIf it is a rubber hose your doing it just unbolts

Replace brake line