20 Most Recent
Questions & Answers
Where is the mass flow sensor on a 2000 saturn sl2?
The Mass Airflow sensor measures the amount of air entering the engine. For EVERY vehicle that is equipped with an Mass Airflow sensor, it is located in the same place...in the air intake between the air cleaner and the throttle body.
On a 2000 Saturn SL2 1.9 twincam,problem with
Did you do a compression test on those two cylinders ? Check spark with spark tester ? of course the advance is going to jump around with a missing engine . Timing issue ,jumped time , engine mechnical problem . Testing an not guessing .
Replaced ignition switch, key, battery and now car wont start after running then it will start up hours later..is it the starter?
When key is turned the starter is energized by a solenoid that applies power directly from the battery to the starter. Any loose connection will prevent the starter from turning over. The solenoid can also have burnt spots on the contacts inside case that will prevent current from getting to the starter. A click noise is the solenoid energizing so
if all connections are tight and the battery is good the only
other problem is the starter may be bad. Brushes on the
starter may have seen their life ended. this is usually identified by tapping on starter with a hammer while trying to start engine. If starter spins, replacement is needed.
I have a clicking sound
Unless it was a sound of your valves beating the top of the motor that is one of the most normal sounds for any operational engine is the click the clicking you hear it's going to be electricity going through your coils so it's pretty normal if you have a distributor base system that would be different I'm pretty sure your car is a OBD2 so it would be a coil base system so I wouldn't worry about it
2000 SL: I have a 2000 SL2 and the A/C stopped working. I w...
A/C compressor clutch relay maybe . It's located in the under hood fuse box . If you look on the bottom of the relay an see pin's 30 & 87 an locate where they plug into the fuse box an jump with a piece of wire . Just to see if clutch engages . Pin 30 should have B+ voltage .
2000 saturn brake lights not working
None of the brake lights work , the center high mount lights too ! I can't believe both tail lamp assembly's going bad at the same time ! Wrench light on means codes are stored in the BCM , did your Mechanic check codes .
Not finding what you are looking for?