1998 Jeep Grand Cherokee - Page 6 - Answered Questions & Fixed issues

tube is located under the car on the passenger side near or on the firewall be careful not to puncture anything up inside there. and dont be directly under it when trying to unclog it. it will drench you.

1998 Jeep Grand... | Answered on Sep 04, 2014 | 70 views

sensor is located on the top driver side of bell housing for you transmission. held in place by 2 bolts with a wire leading to the engine compartment. no fixing it you must replace it. follow wire unplug it and unbolt it from the bell housing and replace it.

1998 Jeep Grand... | Answered on Sep 04, 2014 | 55 views

probably a broken vacuum line under the hood or under the dash. had the same problem with a 97 cherokee found a broken vacuum line on the passenger side firewall under the hood behind the a/c .

1998 Jeep Grand... | Answered on Sep 04, 2014 | 225 views

a tune up will 90% times fix this.
get tune up, sparks , wires, filters. buy the book ever read it?

stalls have 50 causes.
only about 5 tests, solve why
want to gue$$ or test.

1998 Jeep Grand... | Answered on Sep 01, 2014 | 63 views

faulty relay under dash somewhere for high beams or faulty switch on steering column. relay should click on and off suspect relay stuck in high beam on most likely location of relay is under bonnet or side panel on vehicle.

1998 Jeep Grand... | Answered on Aug 14, 2014 | 737 views

high beam relay might be stuck on

1998 Jeep Grand... | Answered on Aug 13, 2014 | 507 views

Short on wiring or loose connection.

1998 Jeep Grand... | Answered on Aug 05, 2014 | 27 views

Hard one :-) climb over remove the cover,slide keeper off the lock fit new barrel and key.

1998 Jeep Grand... | Answered on Jul 21, 2014 | 146 views

My best guess with what you are saying is you did not "RUN" out of gas but actually had fuel still in your Tank. What happened was one of (3) things.. Your Fuel Filter is clogged (but it would have run sluggish or a hesitation prior to this happening. The 2 Most common problems that more than likely happened is either (A) Fuel Pump/Fuse for the Fuel Pump failed or (B) Crankshaft Sensor has failed.

1998 Jeep Grand... | Answered on Jul 17, 2014 | 42 views

check your fuel pump

1998 Jeep Grand... | Answered on Jul 13, 2014 | 66 views

Check the fuses, then the next thing to check is the Freon level. You can get a do it yourself kit at an autoparts store. They are not too expensive. If it is totally out of Freon though, it could be expensive.

1998 Jeep Grand... | Answered on Jul 08, 2014 | 21 views

code, what does that mean?
ahh the computer fear thing, like on all newer cars.
you meant does my PCM need to be reprogrammed to use my new pump.
NO> !

step one says: for pump)
but if you remove the cars battery , some things will forget.
like radio stations, or radio password activation codes.
i think 98 has no radio codes. no NAV , no idle learn codes
and for sure no throttle by wire, re-learn codes.

1998 Jeep Grand... | Answered on Jul 07, 2014 | 63 views

fuel that hits the oil pan can run down the exhaust pipe and put fuel
on the ground, very very dangerous. all cars.
the turbo is the least of worries.
on the JEEPS,we do what is called an injector leak down test.
its in the FSM how to do so.... and the injector balance test.

my answer is , GET IT services, now, and do not park in the garage.

1998 Jeep Grand... | Answered on Jul 07, 2014 | 65 views

catalytic converter or o2 sensor maybe

1998 Jeep Grand... | Answered on Jul 03, 2014 | 259 views

sounds like you have a door switch going bad. or ot could be the liftgate switch.

1998 Jeep Grand... | Answered on Jul 03, 2014 | 36 views

We need more info on just how you damaged the harness plug. If it is just the clip that locks it on to the pcm (the proper name of the computer on a jeep is Powertrain Control Module) simply wrap the unit with a zip tie to lock it in place. pulled tight a cable tie will hold tighter than the plastic clip on the plug,

1998 Jeep Grand... | Answered on Jul 01, 2014 | 19 views

bad lock, or its jammed some how,
the key has to work.
replace the lock. or get a lock smith to fix it.
Id pull the skins and check it very carefully , even remove it
and make sure its not damaged somehow, ice damaged, last winter.
and progressed to worse. most damage does that.
just to be sure, make sure its not in child safe mode.
did you read the operators guide, on that?

1998 Jeep Grand... | Answered on Jun 30, 2014 | 108 views

I've come across a couple with poor battery connections do the same thing...
The EAS/BAS light will turn on and store a pending code when the system detects low battery voltage.

1998 Jeep Grand... | Answered on Jun 20, 2014 | 128 views

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

1,950 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides