20 Most Recent 2000 Audi A8 Questions & Answers

Broken wires to the sensors. Common problem.
Rewire the faulty one(s) and you are good to go

2000 Audi A8 | Answered on Sep 09, 2019

Check this website you fine there fuse box diagram and description for Audi A4


2000 Audi A8 | Answered on Jun 30, 2018

Temp sensor is at the right hand rear of the engine (left side when looking from the front). You can get to it from above without too much issue.
They regularly fail and are a cheap replacement part. They don't throw diagnostic codes. Go genuine, or Bosch.

To replace, you pull the retaining clip out to the rear (be careful, they get dropped easily). The sensor itself pulls out, but will probably be stuck in slightly, so don't damage the cars plug pulling it out (disconnect plug first).
Make sure the o-ring comes out too, or go fishing for it (they can be brittle and break with age). New sensor will come with a new o-ring.

2000 Audi A8 | Answered on Oct 02, 2017

no there is no way to service or repair your shock absorbers, tho it's a pretty straight forward job if you can find the parts yourself

2000 Audi A8 | Answered on Apr 28, 2015

If you have a Auto g/box the problem could be either reverse pump or reverse band.
If you have a manual g/box then its the clutch slipping and the only thing with that is oil on plate.
But it has been known on other type cars was the rear brakes sticking on when hot in reverse.

2000 Audi A8 | Answered on May 23, 2014

Audi radio code vin navigation plus a8 3.7 2000

2000 Audi A8 | Answered on Mar 02, 2014

Run fault codes and look for a faulty TCM unit. THE TCM will also put on the engine light and affect the speedometer operation . Running the fault codes will also identify the sensor associated with the ABS unit.. Seeing as to how you have just bought the car (possibly from a corner used car dealer) I would advise a pressure test done on the transmission to check for the condition of the transmission and have an oil change and the bands and clutch packs adjusted

2000 Audi A8 | Answered on Feb 01, 2014

The big wire to the starter goes to the post he mentioned, that's the starter relay. The big wire from the relay goes directly to the battery. Connect positive to the post, and negative to a good clean ground.

2000 Audi A8 | Answered on Nov 27, 2013

What happen to the car if code po442 is ignored?

2000 Audi A8 | Answered on Dec 11, 2012

First of all you need to access the Engine Control Module (ECM), Transmission Control Module (TCM), and ABS & ESP Electronic Control Unit using VAS, VAG-Com or similar diagnostic equipment connected to the data link connector of the car, in order to pull out all DTC's memored. DTC = Diagnostic Trouble Code. Then you will be full informed about the root cause of the problem, and you will be able to repair & replace bad pieces and reset the ECM, TCM and ABS & ESP ECU.
Let me know please about found DTC's. I will assist you kindly to fix your problem.

2000 Audi A8 | Answered on Aug 15, 2011

Not finding what you are looking for?
2000 Audi A8 Logo

63 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 Audi A8
2004 Audi A8

99 Questions

1997 Audi A8
1997 Audi A8

60 Questions

1998 Audi A8
1998 Audi A8

51 Questions

2006 Audi A8
2006 Audi A8

44 Questions

1999 Audi A8
1999 Audi A8

28 Questions

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14846 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

A8 Audi

  • A8 Audi

Most Popular Question

like know bank 1 location 2000 audi a8

  • Cars & Trucks