1989 Honda Prelude - Answered Questions & Fixed issues

0helpful
1answer

Loud humming noise near fuel tank and loss of

Yes, this is indicative of fuel pump failure. It will need to be replaced.
2/24/2018 4:38:32 AM • 1989 Honda... • Answered on Feb 24, 2018 • 82 views
0helpful
1answer

Buying a 1989 honda prelude that has low psi in 2 chambers in the engine i also have a honda civic dx 1991 as well as a 89 crx there close years enterchangable? the crxman and honda prelude&crx drive!

if the low pressure is between 2 adjacent cylinders, it will be cheaper to replace the head gasket
2/12/2017 3:44:49 AM • 1989 Honda... • Answered on Feb 12, 2017 • 28 views
0helpful
1answer

Why is A/T missing 1st gear?

Your transmission has a failed clutch pack most likely. Sorry.
4/21/2016 11:19:31 PM • 1989 Honda... • Answered on Apr 21, 2016 • 28 views
0helpful
1answer

Main fuel pump relay location

Under driver side dash , above fuse panel
2/6/2016 11:57:44 PM • 1989 Honda... • Answered on Feb 06, 2016 • 198 views
0helpful
1answer

What could be wrong if vehicle will not crank after changing head?

Did you check cylinder compression?
7/14/2015 5:45:02 PM • 1989 Honda... • Answered on Jul 14, 2015 • 51 views
0helpful
2answers

Wont start

battery
4/5/2015 4:42:39 PM • 1989 Honda... • Answered on Apr 05, 2015 • 138 views
0helpful
1answer

When i turn key to start my 1989 honda prelude

Might be your fuel pump itself.
1/5/2015 2:53:53 AM • 1989 Honda... • Answered on Jan 05, 2015 • 182 views
0helpful
1answer

How do I adjust the shift linkage cables.

Your shifter cables are most likely worn out or stretched out. Adjusting the cables moves the shifter arm a little bit. The turnbuckles for adjusting are inside the center console under the shifter arm. To get to them, you have to take out the center console. One cable controls side to side movement and the other controls front to back, don't adjust the wrong one on accident. 25311622-za4bqvjhdrn3arnyccyp5xaz-3-0.jpg
12/7/2014 8:18:05 PM • 1989 Honda... • Answered on Dec 07, 2014 • 361 views
0helpful
1answer

LOOKING FOR A DIAG TREE FOR THE FAN CIRCUIT ON A 89 HONDA PRELUDE SI

Print the parts of a wiring diagram you need, at a repair shop, off their data base Too old for the trouble trees, unless you find OE Factory Manuals on E-Bay or somewhere
10/1/2014 4:22:58 AM • 1989 Honda... • Answered on Oct 01, 2014 • 146 views
0helpful
1answer

Hoq to fix ball joints on a 1989 honda prelude

Replace them, usually with the control arm. This way it will get new bushings, too, which are probably worn.
9/1/2014 3:18:19 AM • 1989 Honda... • Answered on Sep 01, 2014 • 50 views
0helpful
1answer

How is the igniter switched on and off

the computer controls it bot it could be the crankcase position censer ect. have someone hook a computer to read codes on it
8/22/2014 9:38:09 PM • 1989 Honda... • Answered on Aug 22, 2014 • 31 views
0helpful
1answer

Non interference engine?

yes it is an interference engine.
8/3/2014 4:48:21 AM • 1989 Honda... • Answered on Aug 03, 2014 • 84 views
0helpful
1answer

Non interference engine

Honda engines are interference engines which means that valve damage will occur if the belt has broken or the correct procedure is not followed during belt replacement.
8/1/2014 10:23:06 PM • 1989 Honda... • Answered on Aug 01, 2014 • 112 views
0helpful
1answer

1989 honda pop up idling

If you're having a idling problem. .it's usually a dirty throttle body or a sensor dirty or bad ..check for code's if none clean throttle body
6/16/2014 2:40:47 PM • 1989 Honda... • Answered on Jun 16, 2014 • 34 views
0helpful
1answer

Transmission won't shift properly

check fluid levels add if low..change filter if clogged ..
12/28/2013 1:01:09 AM • 1989 Honda... • Answered on Dec 28, 2013 • 169 views
0helpful
1answer

I have a 89 honda prelude turns over but no fire

My honda prelude 1989 runs speed and later it will be slow and cannot run again.
12/18/2013 1:37:12 PM • 1989 Honda... • Answered on Dec 18, 2013 • 142 views
0helpful
1answer

I put my 1989 Honda Prelude engine (auto) into a 1988 shell with manual transmission, and now my revs stay high only when driving and changing gears. Was wondering if it is a vacuum hose issue and how

may need to swap the computer also.. manual computer is different..but yes.. be looking into any vacuum leaks..block off any open ports you find..
12/9/2013 2:59:30 PM • 1989 Honda... • Answered on Dec 09, 2013 • 180 views
0helpful
2answers

My 1990 prelude will not charge the batt while

you will need a new alternator. battery light means there is no charge in the electrical system. always first check the earths and wires before changing the alternator as a faulty earth can also be the main problem.
11/8/2013 5:12:15 PM • 1989 Honda... • Answered on Nov 08, 2013 • 110 views
0helpful
1answer

Won;t start while clutch pressed but will push start

The clutch master cylinder must have gone out, the seals in it have failed. The clutch master cylinder (next to the brake master cylinder) gives you hydraulic pressure so the clutch pedal can operate the clutch.You can buy a new clutch master, a rebuilt unit, or yours can be rebuilt with new seals. Save time and money and buy a rebuilt or remanufactured unit. Once installed, you bleed the system down at the clutch slave cylinder, mounted on the transaxle.
7/16/2013 7:12:31 AM • 1989 Honda... • Answered on Jul 16, 2013 • 144 views
Not finding what you are looking for?
1989 Honda Prelude Logo

211 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Honda Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6929 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14967 Answers

Pierre Laplante

Level 3 Expert

2061 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...