Questions & Answers
How do I adjust the shift linkage cables.
Your shifter cables are most likely worn out or stretched out. Adjusting the cables moves the shifter arm a little bit. The turnbuckles for adjusting are inside the center console under the shifter arm. To get to them, you have to take out the center console. One cable controls side to side movement and the other controls front to back, don't adjust the wrong one on accident.
12/7/2014 6:31:26 PM •
361 views • 0 helpful votes
Non interference engine
Honda engines are interference engines which means that valve damage will occur if the belt has broken or the correct procedure is not followed during belt replacement.
8/1/2014 12:52:07 AM •
112 views • 0 helpful votes
1989 honda pop up idling
If you're having a idling problem. .it's usually a dirty throttle body or a sensor dirty or bad ..check for code's if none clean throttle body
6/16/2014 10:53:29 AM •
34 views • 0 helpful votes
My 1990 prelude will not charge the batt while
you will need a new alternator. battery light means there is no charge in the electrical system. always first check the earths and wires before changing the alternator as a faulty earth can also be the main problem.
10/10/2013 7:25:28 AM •
110 views • 0 helpful votes
Won;t start while clutch pressed but will push start
The clutch master cylinder must have gone out, the seals in it have failed. The clutch master cylinder (next to the brake master cylinder) gives you hydraulic pressure so the clutch pedal can operate the clutch.You can buy a new clutch master, a rebuilt unit, or yours can be rebuilt with new seals. Save time and money and buy a rebuilt or remanufactured unit. Once installed, you bleed the system down at the clutch slave cylinder, mounted on the transaxle.
7/15/2013 11:33:04 PM •
144 views • 1 helpful votes
Not finding what you are looking for?