Top 20 2004 Volvo S80 Questions & Answers

Possible damage to one of the ABS sensors when the axles were removed to replace the transmission. Or one of the sensors is disconnected or not tightened down.

To get appropriate service, take it to a Volvo dealer or a Volvo specialist.

Check your fuse in the drivers side dash with the door open it's right there thanx Chris

Your pvc or so called oil trapp is plugged replace that and look at the engine where it goes in for blockage too that's the problem Regards Chris

Undo the nut & pull arm off then fit new arm, if replacing the motor you need to remove bumber

Car on, add thru low side, ( blue, ), check temp

flash confirms that the car is fully locked. Check if all doors are closed and if didn't disabled alarm.

If it's the approach light under the mirror, the lens pops out to replace the bulb. If it's the turn signal bulb, then the mirror cover has to come off

Hello. If you have a impact gun it will spin off , if not you can use a pair of vise grips and a leather glove. Put the glove around the pully and pinch it with the vise grips. This will help you keep from bending or putting nicking up the pully. Then just turn the bolt until the vise grips hit the side of the housing and you should be able to break it lose.

Possibly the light that illuminates the gear position indicator on cars with automatic gearboxes?

Takes three things to make engine run gas,air, and compression. Plug code reader in get codes ..

Tell us about what has been tested so far, how it was done & the results

It means you must go to the dealer or a reputable Volvo mechanic so they can find out which of your sensors.. either in the bumper, or dash are not reporting. Otherwise it may not deploy at the time of an emergency. Usually this light goes off in older cars that haven't been serviced in a while.

It basically means "Alert!" and will refer to the message in the display to the left in the dash. I see it when bulbs are out or the ABS sensor is alerting me etc. VIDA (software) and DiCE (hardware to plug into ODBII port) will also tell you a lot more about any errors.

front or rear bulb??

It is behind the glove box and under the hood in front of brake master cylinder.

It's attached to the washer bottle.

After you replace the module (under the console), reset with an Autel European ODB (EODB) scanner.

is it red or amber

Have you had it checked for leakage whilst off? Ask for a DC current leakage test from your battery whilst the key is removed. Leakage will result in the battery draining whilst off. If the test show a leak you will need to start/looking for electrical circuits / lights remaining on.