20 Most Recent
1986 Volvo 760 - Page 9 Questions & Answers
1 Answer
I have 2015 volvo 670 d13 truck there are some fault code
you can get guide from many sites.. i know few
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every singl e thing is covered
within seconds u can get the access and it's totally illustrative complete
Volvo Cars &...
|
Answered
on Mar 19, 2019
1 Answer
TIGHTENING THE REAR BUMBER 2000 VOLVO S80
If you pull the trim off (use a plastic spatula to get under it, then just yank with your hands) there are holes in there to reach the bolts.
Get an extension and a socket, I think it's 12mm, and then see if you can just tighten them up a little bit.
Also, the bumpers hang on the body with some clips/grooves along the edges, so make sure that they didn't 'fall out' of the grooves and clips and sag that way.
If so, loosed the bolts, pull the bumper away from the car an inch or two and then push it back in place while aligning the bumpers edges.
Volvo Cars &...
|
Answered
on Mar 10, 2019
1 Answer
Removing horns 2007 volvo s80 3.2
Not too hard. You pop the grille out, which if it is like the S60 and V70, you pop out the reusable plastic rivets on the slam panel under the hood, bend the plastic forward, reach your hand in and push the grille out (or push on the tabs to release it and then push it out).
Then you can access the horns from the front.
It's doubtful the horns are bad, if that's why you want to get to them, but test them with 12v and see.
If they're not working right, it's possible that your alarm module is bad - but that would be another thing to try once you've determine the horns are good.
Volvo Cars &...
|
Answered
on Mar 10, 2019
1 Answer
2013 Volvo XC90 3.2 engine light on
I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manuals
Volvo Cars &...
|
Answered
on Mar 08, 2019
1 Answer
How to remove front driver fender on 2008 volvo xc-70
It's plastic so just pulling it off is not just 4 bolts and it comes off. You have bolts screws and plastic clips to remove. May have to remove the grill headlights and inner fenders and under the car skid plate cover if it's still there. Then find any wires to unplug and then slip it forward and keep looking for screws holding till it comes off.
email for details on
[email protected]
Volvo Cars &...
|
Answered
on Feb 18, 2019
1 Answer
Where is the tcm located in a s60 volvo
Passenger side front of engine large black box contains ECM & TCM
when you remove the cover the ECM is made by Bosch it's Towards the outside of the vehicle.
TCM is made by TEMEC it's on the inside toward the center of the vehicle
Volvo Cars &...
|
Answered
on Feb 18, 2019
Not finding what you are looking for?
