20 Most Recent
1991 Cadillac DeVille - Page 9 Questions & Answers
I have a 91 cadillac deville security light keeps
The security light is a visual indication that something in the car's antitheft system is failing. In most GM cars and trucks there is a hidden system that most people are unaware even exists. From the moment you put your key in the ignition, there begins a constant line of communication between your key's security chip or transponder, to the ignition's lock cylinder, and then to the car's TDM. (Theft Deterrent Module) The TDM is what tells your computer that the correct key is being used and that it is "OK" to allow the vehicle to start and run. These 3 parts must be in CONSTANT communication. If the key is in the ignition, then these parts are sending important signals to each other. The security light illuminates when that signal gets broken, even just for a second. When the signal breaks, (normally due to a failing/broken part) the car goes into antitheft mode. The car misinterperates this and thinks its being stolen or hotwired because it is NOT getting that signal from YOUR specific key. There is where the security light turns on and shuts down your vehicle. So basically, if that light is on, your system has some sort of failing part. This can start as an intermittent "no start", to your vehicle not running for days at a time, to the vehicle NEVER starting again. The problem is electrical and computer based, so don't count on an easy reset button, or the problem fixing itself. The hard part is isolating which part is the problem. You can spend a thousand dollars through a mechanic very easily. I have had great luck with bypassing the entire system. This way the problem will never return. It actually CAN'T ever return because it is eliminated. This can also be done yourself at a much cheaper cost. Read through this link very carefully. You'll find alot of information and pictures, along with ways to help you fix this.
http://vatspasslockpasskeysecurityhelp.yolasite.com/
How do i replace the
If it is necessary to remove the heater assembly, the cooling system must be drained before removing the heater core.
When a heater core leaks, a new heater core is installed or the old one repaired.
Heater Housing
- The heater housing is usually under the dash and must be removed to gain access to the heater core.
- Procedures for replacing the heater core vary with the year, make, and model of car. It threfore necessary to consult the manufacturer's repair manuals for the proper procedure for replacement.
The heater housing is disassembled to get to the heater core.
Heater Core
- Remove the access panels(s) or the split heater/air conditioning case to gain acess to the heater core.
- Remove the heater coolant hoses.
- Remove the cable and/or vacuum control lines (if equipped).
- Remove the heater core securing brackets and/or clamps.
- Lift the core from the case. Do not use force. Take care not to damage the fins of the heater core when removing.
- To reinstall the heater core, reverse the removal steps.
When the heater core leaks and must be repaired or replaced, it is a very difficult and time-consuming job primarily because of the core's location deep within the firewall of the car. For this reason always leak test a replacement heater core before installation.
Heater blower works just don't get any air at all
The heater blend door actuator is not opening the door.Check for power at the actuator and if you have power at the actuator and its not working then replace the actuator.These actuators are a well known culprit of this problem.You find the actuator behind the glove box it will have a small arm on it that operates the heater blend door.
Not finding what you are looking for?
