20 Most Recent 1990 Acura Legend - Page 8 Questions & Answers

drain coolant, locate thermostat housing on engine at end of lower radiator hose, loosen clamp to remove hose from housing and disconnect sensor...remove bolts and carefully remove housing from engine. Inspect parts and replace anything worn (such as swollen hoses, damaged housing, defective temp sensor). Sealant is not necessary to re-install the thermostat.

hola tengo un problema con mi carro es un acura legend 89 el corro prende bien y calienta lo normal pero cuando le pongo la rrebersa o la D ola 2 el carro se apaga deimediata mente mepueden ayudar y desirme cual es el problema porfavor?

it sounds like an over loaded circuit breaker. check for correct rating for the lights in use.

An electrical current draineg: something other than Computer Memory& your clock is staying on or not timing outYou shouldn't have more than 35 to 80 Milli-Ampsall the time,depending on the vehicle

You need to have someone you trust to look under your car for leaks. For that amount of oil loss the leak should show a trail of oil.There is a rear main seal and it is where the transmission and engine join. Often the oil pan is in the vicinity of this part. Perhaps the repair was misdiagnosed and you actually had a bad rear seal leak instead. Depending on how this style seal is removed, it may require separating the engine from the transmission. Or the repair did not last and you should go back to have it corrected.If there is no leak under your car, then the oil is going somewhere. The valve seals are the next most probable place.I hope my solution is helpful, please rate my info.

no you can have that one rebuilt or buy another transmission but thats about it

Enjoy your freedom

check if you have a blogged air filter,fuel filter or insufficient fuel into injection system either due to fuel filter or low fuel pressure due to fuel pump

If it is like my ford, you simply unscrew the gear knob off, you may need to untighten the screw/bolt below it. Then you may need a fine blade screwdriver or similar to prior out the plastic panel, when you lift this out as you raise up the shaft of stick, you may find a a couple of wires attached below , have a close look if you can, if one looks like a square plug that you can depress and remove its probably not that one. The other you can't possibly see that well but you may if you can get a hand to it twist it and remove. Here you should find your lightbulb. Simply pull out Race to an auto store or brand dealer and get another replace and hey presto.

What about this? Your ECM lost comunicatios? Need to find some replacement? Try this:- ECMTips2- ecupanuveaplHope this helps.