20 Most Recent 2002 Acura 3.2TL - Page 7 Questions & Answers

it could be the ac blower motor needs to be replaced.

2002 Acura 3.2TL | Answered on Jul 01, 2010

Remove the fuel filter,see if when you turn the key on,if fuel will come out the fuel line,then check the fuses,then,replace the fuel pump,and strainer,and fuel filter.This will be the better test.

2002 Acura 3.2TL | Answered on Jun 30, 2010

Check fuses and belts. If not it could be electrical.

2002 Acura 3.2TL | Answered on Jun 29, 2010

There is a fuse. Check carefully, you might have more than 1 fusebox. It may be tagged "running lights" If you head lights still work, check the accessory fuse(s)

2002 Acura 3.2TL | Answered on Jun 09, 2010

If the horn only honked once it may be a symptom of your car alarm being set off after power has been re-applied. If the horn stays on after you reconnect the battery you have either a stuck horn button on your steering wheel or a stuck horn relay. Or it could be the alarm sounding the horn but that usually that occurs in a series of horn blasts (rather than continuous) and the car indicators usually flash in sync with the alarm sounding.
If the horn is stuck on in a continuous blast ie not sounding on and then off and then on etc etc, disconnect one the battery cables then pull the fuse that feeds the horn or pull off one of the removable spade electrical connectors from one of the 2 terminals on the horn itself. Usually the fuse box is either under the dashboard on the drivers side or could be under the hood. Consult your user manual for your car for fuse and horn locations.
If the horn is stuck you need to visit a qualified auto electrician, or perhaps you have a friend who knows his way around auto electrics?
Steve (Melbourne, Australia)

2002 Acura 3.2TL | Answered on May 12, 2010

SRS is your air bag system its basically not operational at this time. Bring the vehicle to a repair shop they will scan the ECU for codes , do the necessary repairs and turn off the lite.

2002 Acura 3.2TL | Answered on Apr 19, 2010

Re-set the ECU. Remove the negative battery terminal, wait a minute or so and re-fit it. This will return all settings to factory defaults and should remedy your problem.

2002 Acura 3.2TL | Answered on Apr 19, 2010

moz-screenshot.pngmoz-screenshot-1.pngdrivers side rear

2002 Acura 3.2TL | Answered on Apr 17, 2010

there is a security code you have to type in you only get ten tries then it locks up. the security code should be hand written in the manual some where. if you cant get it you will have to pull out the stereo and get the serial number and call the acura people and they will give you a code. but you need the serial number off the back of the stock cd player.

2002 Acura 3.2TL | Answered on Mar 18, 2010

you must mean 161000 miles and if you can go 200000 miles and then change, the answer is no!!!. YOUR PLAYING WITH FIRE IF THAT BELT SKIPS OR BREAKS HEAVY ENGINE DAMAGE WILL OCCUR,That belt should be changed ever105,000 miles, you are way over due! sorry for the bad news but these are the facts.

2002 Acura 3.2TL | Answered on Mar 10, 2010

check the rev limiter please rate me

2002 Acura 3.2TL | Answered on Feb 12, 2010

If it's pulling hard when stopping, then one brake pad is probably thicker than the other or the brake system needs to be bled.
For the engine revving on it's own, check for vacuum leaks, Or IAC valve or camshaft position sensor could be bad. You can test any sensor with an ohmmeter in the ohm position placing one probe on each connection point of the sensor.

2002 Acura 3.2TL | Answered on Feb 12, 2010

Check the fuse. There are seperate fuses for right and left. You dont mention if the high beam works for that side? If it does, the fuse is good. The GREEN wire at the bulb is the ground for the low beam. If that wire has power, then the ground is bad. If the high beam works, the hi'lo beam switch is good, and there is a problem between that headlight and the Engine Compartment Junction Block. When the low beam of a car headlight quits burning, there could be several reasons why. Follow these steps to determine how to fix a low beam headlight that is out of commission. 1) Locate the fuse box. fuse boxes are under the hood, but most of them are on the driver's side, beside the steering wheel. 2) Look for the diagram of the fuses inside the fuse box cover. Locate the fuse to the headlights and remove it. Inspect the fuse to see if the wire connecting both sides of the fuse is broken. If the wire is broken, then the fuse is blown and you need to replace the fuse. If the wire isn't broken, then there's another problem causing your low beam headlight to not work. 3') Change the headlight bulbs. To see if it's just a blown bulb, take the bulb from the side that works and put it in the side that doesn't. If the bulb shines, return the bulb and put in a new headlight bulb where one burned out. If the bulb doesn't shine, then the problem may be in the headlight switch or the wiring. 4) Use a voltage meter. Turn on the ignition and the light switch to find out if current is getting to the headlight. Use the voltage meter to see if fire is getting to the headlight. If the voltage meter shows there's no current, then the problem is either the wiring or the headlight switch. 5) Replace the headlight switch. If this doesn't fix the problem, then replace the wiring yourself or have a reputable shop replace it for you. This will help. Thanks please keep updated.please do rate the solution positively .thank you for using fixya.

2002 Acura 3.2TL | Answered on Jan 29, 2010

Hello! In order for me to address this fault, I'll need a brief description of what has been done; Headlight switch, relays, wiring etc...

Just send a comment and I'll get to work on your vehicle fault...

I am here!.................saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

2002 Acura 3.2TL | Answered on Jan 10, 2010

rubbish ,disconnect battery then do it

2002 Acura 3.2TL | Answered on Jan 03, 2010

possible low anti freeze, air bound heater core, defective heat blend door control servo. Start with coolant level, if o.k. check hoses feeding heater core. If the lines are both hot suspect blend door servo/control unit. If only one hose hot suspect clogged/air bound core. Special bleed procedure for engine. With engine running, check for bleeder scews at upper hose mounting, open bleeder and watch for steady stream of coolant. Be careful as coolant is hot. If this does not help, disconnect hoses frm heater core when cool and blow out core with compressed air to unclog system. I hope this helps.

2002 Acura 3.2TL | Answered on Jan 03, 2010

Your engine is overheating? Really need more specifics here...
1. Check your oil level. You don't want to run your engine without oil.
2. Check your antifreeze level. If the level is good but the car overheats quickly, I would suspect a sticking thermostat. They're inexpensive and easy enough to replace... but a must. You could damage your engine if it overheats.
Hope this helps... Good luck!

2002 Acura 3.2TL | Answered on Dec 24, 2009

Is the coolant level ok? After replacing the thermostat, did you bleed the air from the system? The bleeder should be at the front (on engine near radiator). Low coolant level, or air in the system can cause what you describe.

2002 Acura 3.2TL | Answered on Dec 03, 2009

Not finding what you are looking for?
2002 Acura 3.2TL Logo

291 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Acura TL
2000 Acura TL

423 Questions

1999 Acura TL
1999 Acura TL

414 Questions

2004 Acura TL
2004 Acura TL

359 Questions

2003 Acura 3.2TL
2003 Acura 3.2TL

278 Questions

Top Acura Experts


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14852 Answers

john h

Level 3 Expert

23515 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

TL Acura

  • TL Acura

Most Popular Question

code p1456 dtc see dealer manual

  • Cars & Trucks