20 Most Recent 2002 Acura 3.2TL - Page 4 Questions & Answers

Theres one under the hood and 2 at each end of the dash board. It would help if you told why you were looking for it. It depends what fuse you are looking for.

crank sensor may have been damaged

ckeck your connections @ the blower and switch and resisistor

Error one is loading system failure, what you must do is remove the deck and have it repaired.

Probably under the hood. Look for a plastic cover under the hood near the front of the engine compartment. Remove the top, and you should find your fuse box.

This information cannot find in internet, remember that radio code is unique each vehicle. See ACURA FAQs for official info about this topic owners.acura.com/site/site_sitehelp.aspx#faq14Also GO HEREYou Will Need Vehicle VIN Number Phone Number and Zip Code matching those on file Device Serial Number: Radio and / or Navigation Hours of Operation.Alternate ways to contact Acura are listed below:By Phone: (800) 382-2238Monday through Friday, 6:00am to 5:00pm Pacific Standard time at the toll-free phone number above By Fax: (310) 783-3535 By Mail: Acura Client Services Mail Stop 500-2N-7E 1919 Torrance Blvd. Torrance, CA 90501-2746 Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer. Thank you for using FixYa, have a nice day and Merry X-mas.

you will need to establish what the cause is if it is a factory fitted unit and your car 2002 or newer it will have diagnostic plug in the right hand foot well just under the dash this is called OBD2 socket a reputable garage will have the equipment to plug in and read the codes back from your car and should display your sub woofer problem, if this is self fitted then it a case of tracing your circuits and testing your amps good luck

• For coil wires.

1. Remove the intake cover.
2. Remove the right side engine cover - A -
3. Remove the left engine cover - B -
4. Remove Right rear engine cover - C -
5. To remove the #6 coil you will also need to remoce the heat shiel off th reserve tank and the reserve tank as well.

• For coil pack.

1. Remove negative battery cable
2. Remove engine covers show in diagram.
3. Remove the coils (listed above).
4. Now just remove the mounting bolts to the coil packs.

• Please Note - Don't loose the firing order of your car will not run.

• Here is a spare one in case you get mixed up.
• Firing order is
• 1-4-2-5-3-6

• If you have any comments please feel free to leave them here.
• Hope this helps and thank you for using FixYa.

Regards, Tony