1989 Subaru Gl Wagon - Answered Questions & Fixed issues
How do I replace 1989 subrau main bearungs
IF it has a 2 piece block (like the old VW engines ) then you will have to pull the engine . To get the correct answer I suggest that you invest in a good workshop manual for the vehicle and study it . It will have all the necessary information that you will need to do the job.
How do i replace my heater core? my heater stopped
heater core would need to remove the inside lower dashboard near the glove box - be careful you may be messing near airbag sensors as well,. are you sure it is the heater core, not the fan?
The BEST way is to grab a chilton.s or haynes repair manual - from your local parts store or otherwise check out at your local library - call ahead to be sure it is in stock at either place... you might find it at the library, there is also one place online you could subscribe to for the same fee, not sure the website name, your parts store would also know.
Best regards
Ck
Wires run from my battery
Ummmm, not too sure about your exact setup, but your description sound like high resistance electrical issue. Connections carrying heavier loads often fail. The only long term fix is to completely replace or wire around the failed area, anything else gives short repair life.
You MUST follow the wire back far enough to be past ALL evidence of overheat. Oxidation happens after the wiring overheats, and you cannot connect to these areas on the wires.
I have A 1989 subaru gl I put A belt on the ac
i havent seen it only you have but yes it could be a freon leak ,this is what comes of these tins of gas which should be banned ,you must use the proper machine as it weighs the gas ,also it will vacumn the unit so you just leave it connected to the machine for 10 mins and any loss of vacumn indicates a gas leak .simple but these cans of gas cause more hassle than enough also this causes ozone depletetion and selling it through outlets where it can get into untrained hands?? to be be used in known leaky systems .Not a good idea
Noisey lifters, only somtimes
I would get ready for an oil change.But first, make sure the oil level is about 1 quart low. Buy a can of Marvel Mystery Oil and pour all of it in with the rest of the motor oil and start it up and let it idle for 1 1/2-2 hours watching the temp to make sure it does not get to hot.Then do your oil and filter change and let it drain for at least 30 minutes.
The Marvel is a great detergent cleaner and will wash the dirt into your old filter.
You can also put it in your gas tank to do more cleaning.Read the can.
Not finding what you are looking for?