1995 Jeep Grand Cherokee - Answered Questions & Fixed issues

Might just be that the pesky ecu needs to be rebuilt. They were known to be failure prone.

No obd 2 since it's a pre 1996 vehicle, so its obd 1. Start turning that key on-off-on-off-on, to get ck engine light to flash out codes.

Rear main seal of engine is leaking. Tough to change....have to drop tranny and remove the flywheel, to get to it.

You will need a OBD 2 scan tool to retreve your code.If you hve not one go to a garage they will retreve the fault code for you.However you might consider makeing the purchase of one through a car part store near you.

Check here...

Cargo Cover for 1995 ZJ


1. Link: Jeep Grand Cherokee Cargo Cover
If you can't find what you're looking for please email us ( [email protected] ) and we'll see what we can do for you.




2. Link: Jeep Grand Cherokee Cargo Cover (eBay)


Cargo Carpet for 1995 ZJ


1. Link: www.autoanything.com/cargo-liners


And, in a curious way, a user in this forum could not find the accessory use the idea of keeping a folding table in place of "cover".

Good luck.

is this a USA jeep or export? (immo differences) we do not know what turn over means. in this case you meant engine cranks fast and will not start. Changing out the CKP was a bad idle. 1 of 4 , engine, 4L (veries but unstated trans) must be calibrated or its wrecked at the first turn of CRAnking . So be ready for 2 causes of dead spark is that fun ,no. this is what you did wrong, if compression is ok. 1: check all fuse first. we test all ones that look ok. see? 2: then we scan it cranking, or all this is hopeless, see why? it will tell you why there is no spark, but you skipped step 2. 3: not only that but you didnt check the ASD relay. if its not pulling in the PCM is telling you why. if its pulling in and dropping out, then pcm tells you why. if ASD holds in full time cranking PCM is happy in this regard. there 6 to 8 reason for ASD to drop. one is immoblizer upset. I will stop here, as spark needs to be corrected. here is the no start page. spark dead help, knowing that. sparks dead so no need to read the no start page, we go right to ASD tests see the 8 ways? (yours will be less than 8, for 1993) http://jeepdied.com/ASD.html this is the only tool i know that scans 93/95s https://www.amazon.com/INNOVA-3120-Diagnostic-Reader-Vehicles/dp/B000KID2ZC/ref=sr_1_1?s=automotive&ie=UTF8&qid=1395411804&sr=1-1&keywords=INNOVA+3120 nowt the alarm VTA deal. The ZJ 1993-1995 VTA does not cut the engine via ASD (IMMO) in the USA, but in Europe it does (if opted there) see its really the world wide web, and ive no clue where you are or what engine you have. nor options like VTA (T is for theft)

if it starts using ether, it suggests a clogged fuel filter. You need to know what the true psi value is across the fuel rail. you can rent kit from major auto parts stores. be it remembered that many cars nowfays have 2 fuel filters- one in tank and one on frame or firewall. a quick check is back pump air through your fuel line till you hear bubbling. recheck fuel pressure and note diffetence. if it goes up you probably icked up larger debris on the screen.

How old is the battery? Older ones can get weaker over the years when they are under strain. Especially on a big V8. Go to a battery specialist and they can test it 'under load' to see if it's strong enough. When you turn the key does it catch, miss and die or does it just wind? Does it idle roughly once started? Please use the 'Comment' button below with the answers if you can Try putting a dose of good quality injector cleaner through it. Put the cleaner in and just let the vehicle idle for 10 minutes. That way you get a stronger cleaning mixture going through the injectors.

Have you checked the ignition switch (and wiring to the relay block from it)?

It sounds like the radio is defective, but check the fuses that power it 1st, if they are all ok then you can get a used working radio on Ebay, have bought them there myself with no problems, cost was reasonable.

tighten screw -bracket -and or nuts

disconnect battery put a test light between neg of battery and neg of cable if it lights u have a draw if so take out inter lamp fuse if still there put test light back on batt and cable and start removing fuses till lamp goes out then u know what cirit is drawing
common causes glove box lamp int lamp trunk lamp radio good luck

Bare or burned wire, most likely battery cable or alternator cable near exhaust system which might be making contact with a metal part somewhere, off and on, because of bumps, vibration, etc.

no it doesnt ... check out heatertreaters.net if you have to replace the blend doors .... but the actuator is directly behind the glove box...remove the glove box take out 3 screws and remove actuator and replace.....waa laa

Por que el compresor de mi Saturn ion 2004 prendo la unidad de aire acondicionado enfr?a pero no Tumba se keda prendido

Likely to be the blower resistor

Hook up a gauge and see what fuel pressure you have. Do an upper throttle body clean.

Get your heater core checked. May be leaking.

How to turn the lights on the information center, in a 1996 Jeep grand cherokee

I have a 1995 Jeep sport it crank but wont start I dont know what it could be