20 Most Recent
1991 Audi 90 - Page 9 Questions & Answers
Location of ecu relay on 2005 Audi A4 Quattro 1.8t
Here is the manual https://www.google.com/url?sa=t&source=web&rct=j&url=http://ww2.ac-poitiers.fr/vehicules-materiels/sites/vehicules-materiels/IMG/pdf/schematique_din-2. pdf & ved = 2ahUKEwiuwLXBm_jsAhWRnxQKHZA1B6gQFjAKegQI
07 audi a4 audi concert radio stuck in safe mode 2
The following is the procedure to re-activate the radio if the display shows "SAFE". It is important that the procedure be followed in the correct order.
1. Turn on radio. The radio display shows "SAFE".
2. Press the FM2 and RDS buttons simultaneously and hold until "1000" shows on the display. Release the buttons. Do NOT press these buttons again, otherwise the radio will consider "1000" to be the code.
3. Use Preset buttons 1 ... 4 to enter the four-digit code number from your radio card. Preset button 1 corresponds to the first digit, Preset button 2 corresponds to the second digit, etc. Each press of the button increments the number by 1.
4. Once the code shown on the display is correct, press the FM2 and RDS buttons simultaneously and hold until the word "SAFE" appears in the display, then release the buttons.
5. The radio should unlock and be usable shortly afterwards.
6. If an incorrect code is entered, the word "SAFE" appears, first flashing and then continuously. You can repeat the above steps to unlock the radio once more, the number of attempts will be shown in the display. If an incorrect code is entered again, you radio will be locked for about one hour. After one hour - the radio must stay on and the key must remain in the ignition lock - if the display goes out, the you can repeat the above procedure to unlock again. The cycle - two attempts, one hour lock-up - still applies.
7. If you lose your radio code, contact your Audi dealer.
Currently experiencing turbo coming and going on my 2091 audi tt
I'm assuming here that you are familiar with driving turbo engines. What do you mean by 'coming and going'? Are you losing boost as your driving or is it not building pressure as you accelerate? This sounds like it might be a 'boost' leak issue. This could be anything from a loose pipe clamp, a faulty wastegate set up to an actual turbo issue.
Give the turbo set up a basic check. Check all of the pipes and clamps to see if any are loose, split or damaged. A hole or leak in the system can cause pressure loss especially at higher engine speeds.
Is the turbo making any strange noises? Get a helper to rev the engine up to 3000 rpm and hold for 3 or 4 seconds and back to idle. Listen for grinding, hissing and rattling noises. Hissing at a steady engine speed suggests a pressure leak. grinding and rattling suggests a faulty turbo.
I would suggest taking it to a turbo specialist as this sounds like it will need to be tested 'under load'.
1992 audi 500sel trunk lock not responding to the key or remote?
I'm assuming yours is a South African model? Try the simple stuff first. Check the battery in the remote is ok, (Does it work for the doors?). Using the Key manually in the lock should open the trunk as it's an old style 'lock and key'. Check the key slot isn't clogged with dirt or rust. Give it a generous squirt of releasing fluid, (WD40, GT85 or similar). leave it for an hour to soak in then gently work the key left and right to release it. There could be a blown fuse but I don't know which one it is as some vehicle features share a fuse. Has anything else on the car stopped working? Things like the interior light or the cigar lighter? This could be a clue as to which fuse has blown.
The is no spark on my audi
Hook up a scanner to see what the computer is reading. Check the codes. Could be any number of sensors. Make sure that all the fuses are ok.
P3348 audi 3.0 tdi
(P4606) OR P3348 TURBO SARJ shows an actuator problem. this can be the EGR error of exhaust manifold blockage. before unscrewing the actuator. clean manifold and egr system and pipes. If your egr system looks good. If you still get the p3348 fault after the tubing is cleaned. Check crankshaft sensor and engine sensor. we look at the latest actuator. some engines show p3348 but hide true errors. 1 Exhaust EGR system see manifolds and pipes. 2. Check your throtty body. 3. Check engine sensor and crankshaft sensor.
How to turn off Audi 100 1994
If you have then removed the keys or if you have any other problem in turning off, you can directly turn it off by removing the battery
Not finding what you are looking for?