20 Most Recent 1992 Lexus Sc 400 Questions & Answers

There are two large clips at the front of the seated part of the back seat. Lift from the front-center section on both driver and passenger sides. Once unseated, lol, lift up and forward. Careful not to crack the plastic around the seatbelt connectors. Other than the four bolts at the base of the lumbar section of the seat, that should do it.

1992 Lexus Sc... | Answered on Jun 14, 2020

YES.... with out a doubt , it will stumble , won't idle well , sputters and eats gasoline, if you have 2 and i think yours dose have, you need to make sure if its the #1-0/2 sensor before the catyl. or #2 0/2 sensor after catyl.?? , & again, if you own a computer car , get the repair manual for that vehicle from your parts house, worth every dime you spend on it.

1992 Lexus Sc... | Answered on Feb 26, 2018

Could be your compressor for the air conditioner they go sometimes and become tight causing overload on the motor.

1992 Lexus Sc... | Answered on Feb 16, 2018

The blinking O/D indicator is alerting you o the fact that your Lexus has transmission trouble.

1992 Lexus Sc... | Answered on Jan 12, 2018

Wish I was near, I have the same car. And i know a lot about this car. I had the car for about 9 years now. I think i touch every inch of this car, except for the tranny. If you run into any problems, post them. I will be around. GL.

1992 Lexus Sc... | Answered on Jan 10, 2018

Hi aptaylor82, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? Need the year make and model

1992 Lexus Sc... | Answered on Jan 10, 2018

I would like at the CATS, they can get clogged, this would also cause the gas smell in the cabinet. GL

1992 Lexus Sc... | Answered on Sep 12, 2017

check ECM fuze , also look and make sure all plugs are pluged up reset EUC which fuse exactly( google it) alot of steps

1992 Lexus Sc... | Answered on Sep 09, 2017

Change air filter and TPS (throttle position sensor). It is subject to Physical wear. (1992, Age). A dirty air filter can put the MAF sensor out of range.

1992 Lexus Sc... | Answered on May 23, 2017

The obd 1 is located under hood some are located in fuse panel and others just have rubber coversl. Eithet way look for e1 te1 use jumper wire and connect them then proceed to turn igntion to koeo. Count the number of blinks to get code.

1992 Lexus Sc... | Answered on May 01, 2016

Your almost there. Look at where the steering wheel sets and the ignition switch. There will be a bolt to remove or not. ( I haven't worked on your car), No bolt, then look to the top of the switch. There is a hole there. You have to use a small punch or screw driver and push down, when the key is in the run position, then pull the cylinder out. Either way, the key has to be in the run position.

1992 Lexus Sc... | Answered on Jul 05, 2015

Is the shifter stuck in park or it moves and nothing happens?

If you need further help, I’m available over the phone at https://www.6ya.com/expert/oscar_403cc49e0f00cda7

1992 Lexus Sc... | Answered on Jun 15, 2015

Not finding what you are looking for?
Cars & Trucks Logo

Popular Tags

249 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Lexus Experts


Level 3 Expert

85239 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

SC 400 Lexus

  • SC 400 Lexus

Most Popular Question

sc 400 smoking runs funny low revs

  • Cars & Trucks