1997 Audi A6 - Answered Questions & Fixed issues
Low pressure on transmission/not enough to shift
I recently tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. It would'nt move forward or reverse, engine was good both solenoids for forward
and reverse worked, but still couldn't diagnose the problem.
I don't have much technical knowledge but I just followed it step-wise, and now it works perfect! covers wiring, diagrams, torque specs, PCV, everything
got it from
www.reliable-store.com
3/22/2018 3:39:44 PM •
1997 Audi A6
•
Answered
on Mar 22, 2018
•
66 views
Transmission
Sounds like this car was submerged in water sometime in its life.
What is your specific question ?
5/5/2017 5:33:50 PM •
1997 Audi A6
•
Answered
on May 05, 2017
•
94 views
AC stops working when cabin temp reaches 109-110
indicates gas pressure and condenser cooling problems
check the condenser fan is working properly and have the gas pressures checked by gauges
check that the evaporator fins are clean and not blocked as ice build up will cause the same indications
4/7/2017 11:20:10 PM •
1997 Audi A6
•
Answered
on Apr 07, 2017
•
162 views
Cluster problems
Check fuses first. Also check all pcm harness connections
6/22/2014 10:46:49 PM •
1997 Audi A6
•
Answered
on Jun 22, 2014
•
297 views
Pollen filter replacement
A LOT OF POLLEN FILTERS ARE LOCATED IN THE ENGINE COMPARTMENT JUST BELOW THE WINDSCREEN, NOT SURE WHICH SIDE, ALSO SOMETIMES UNDER THE COVER WHERE THE WINDSCREEN WIPERS ARE.
5/14/2014 1:57:39 AM •
1997 Audi A6
•
Answered
on May 14, 2014
•
773 views
Interior door handle
Audi's use whats referred to as a bowden cable which is the equivalent of a lock rod. You can try this if you're handy but you must remove the door panel. Be sure to order door panel clips ( at least 8) because YOU WILL break some removing the panel. Tedious job....you might want the dealer to tackle this if your not sure. A damagrd door panel can run upwards of $400. I’m happy to assist further over the phone at
https://www.6ya.com/expert/howard_977676954994c5b2
5/13/2014 1:59:55 PM •
1997 Audi A6
•
Answered
on May 13, 2014
•
84 views
Cluster problems
I had a problem like that before with ford focus (apparently common fault) what I did was unscrew cluster from dash board remove main board, brushed it down with soft brush and gave a spray of wd40, put it back and have never looked back. Garage was gonna change me over 600 to replace. Luckily I found solution on Internet hope this helps.
5/10/2014 5:43:35 AM •
1997 Audi A6
•
Answered
on May 10, 2014
•
220 views
What if you use other atf instead the one designated for audi?
Sounds like your trying to explain that you have aworn out & failing transmission in need of am completerebuildUsing the wrong fluid may or may not hurt it but it willeffect shifting qualityI things you beyond that point & need a new trans
3/6/2013 8:05:42 PM •
1997 Audi A6
•
Answered
on Mar 06, 2013
•
139 views
Not finding what you are looking for?