20 Most Recent
2001 Suzuki Esteem - Page 2 Questions & Answers
How do you replace crankshaft position sensor on 2001 susuki esteem?
why not post the symptoms? no start, what?
id bet 100% its not bad,
what to find the truth,
use a scan tool to see
RPMs on OBD2 scan, shows 0 rpm crankiing
and cranking for 5 seconds (release key,not off) see P0340 or P0355 or simular DTC? do you? bingo !! The ECU does tell you if
the CKP is bad. sure does. if you look. saving big money if not.
O2 sensor chevy
Problem with 2001 Suzuki Esteem
O2 sensor chevy
??????????????????????????????????????
is this an engine swap, chev to suz or suz to chev?
and what is the quesiton, no actual question was posted, ????????
Remove front rotor
SOMETIMES THERE IS A SCREW THROUGH THE FACE OF THE ROTOR BETWEEN THE LUG STUDS. IF YOU CANT GET IT LOOSE IT IS OK TO DRILL IT OUT. IT IS ONLY THERE TO HOLD THE ROTOR ON DURRING PRODUCTION.
2001 suzuki esteem stalls--auto shop wants to
Doubtful it is badSeek a different shop & be there,so you can see the actual testingor forget itMost likely not even the problemYou can get one from a salvage yardor online & install yourselfDon't need a shop to remove 4 bolts
Replace transaxle 2001 suzuki esteem
you need and expert mechanic to look and access this damage.its non trivial.. and if not investigated proper can be very dangerous.if really curious of all the long steps to do this,alldata.com is your ticket.
SUZUKI baleno
Check crank angle sensor. Mine run until warm, pinlks badly/stalls, engine check light then comes on a car runs ok. Ran diagnostic and came back with a faulty crank angle sensor
Hi! What are the correct
if you take off the upper belt cover and line up the top dead center timing mark the cam mark will be right on or off 180 degrees. Line up the dot on the cam with the arrow by rotating the crankshaft around till both the cam mark and the crank TDC mark line up. Now when you take off the lower cover all the marks will line up for the crank. They are usually pretty obvious, but if your are not sure at this point you can always paint your own. Just make sure when you slide the new belt on , all the timing marks line up.
Not finding what you are looking for?