20 Most Recent 1992 Mercury Sable - Page 9 Questions & Answers

You can get your choice of information by reading the results of a specific Web search. I would enter the name and year of your car and then add fuse diagram or fuse location. The results will not only give you a diagram to print, but may include You-Tube videos or color photos. In addition, if you do not have your Owners manual, the results can show the application of the fuses and which things are grouped together for 1 fuse.

That is called running on, you need to see a good mechanic to sort it out , it is a symptom of problems

You most likely don't have any grease fittings. Most front ends are "lifetime lubricated", and they save money by not putting zirc fittings on them.

Probably the only place you will find one is in a salvage yard.

Let me know what size engine and I will keep my eyes open for one.

Sounds like the control cable form the inside latch is broken of slipping. That is a hard one---may have to take it to a repair place.

battory is bad it runs fine just altoter is runing so buy a battory and it should work fine

Are you still using the spark plugs with the center tap? If so, I would go with the no tap plugs. Although the check engine light is not on, sometimes there are still error codes in the system, so just to be sure I would check..

Have you done a compression check on your cylinders? That might give you a clue on what is happening with the engine. You might also want to join the http://mercuryforum.com/forum/ and see if other Mercury owners are experiencing the same problem.

drop the transmission, and starter,, its between the tranny and the back of the motor, I don't have the make and model or I could help you find a breakdown of the process,

Give some more details of the problem.

Just go on the Web address bar and type in "1994 Mercury Sable Fuse diagrams". You will get Hits from many sources. Some will show a collage of small photos, then expand them. Autozone has a feature,in the Help section of the page, but you must register your vehicle and maneuver to the Free section.

Time for a rebuild Can't fix slipping The internal damage is done When your pulling out from a stop your in 1st gear OD comes in at 42 mph or above

IF the fuse diagram isn't on the back of the cover, you'll have to go to the owners manual. Back of the fuse box cover is where it always is.

This Code is for the Coil circuit or the lack of a signal pulse from the crankshaft sensor to the Coil circuit. It is not a fuel code.

Is the engine reving high?if not find out if the tach runs off your distributor.cap and roator.there's a wire check if hooked up properly.need more info.

You most likely need a new thermometer

If it's that tight it would be easier to remove the lower back seat and remove the 18 mm bolt and remove the seatbelt anchor. To remove the lower back seat pull up sharply on the front left and right sides of seat, only held in with plastic clips, then seat will pull forward and ouy

Possible timing belt failure. Sure it has gas?

look under the bonnet very close to where the brake pedal is, driver side, you should see small white reservoir